Cisco ASR 5000 Installationshandbuch - Seite 14
Blättern Sie online oder laden Sie pdf Installationshandbuch für Netzwerk-Hardware Cisco ASR 5000 herunter. Cisco ASR 5000 33 Seiten. Applying power and verifying the installation
Auch für Cisco ASR 5000: Installationshandbuch (18 seiten), Installationsverfahren (8 seiten), Installationshandbuch (37 seiten)
Seite drucken
Checking the LEDs on the SPIO
SPIO Standby LED States
The Standby LED on the SPIO indicates that software is loaded on the card, but it is serving as a redundant
component. For the SPIO installed in slot 25, this LED should be green for normal operation. For the SPIO
installed in slot 24, this LED should be off for normal operation.
The possible states for this LED are described in the following table. If the LED is not green, use the
troubleshooting information in the table to diagnose the problem.
Table 13: SPIO Standby LED States
Color
Description
Green
Card is in redundant mode.
None
Card is not receiving power.
OR
Card is in Active Mode.
SPIO Interface Link LED States
The Link LED, associated with a particular SPIO interface indicates the status of the network link. This LED
should be green for normal operation.
The possible states for this LED are described in the following table. If the LED is not green, use the
troubleshooting information in the table to diagnose the problem.
Table 14: SPIO Interface – Link LED States
Color
Description
Green
Link is up.
ASR 5000 System Administration Guide, StarOS Release 21.2
14
Troubleshooting
None needed for SPIO in slot 25. If green for SPIO in slot 24, check the status
of the SMC installed in slot 8.
If the SMC in slot 8 is in standby mode, it is possible that there is a problem.
Monitoring the System for show commands, the outputs of which will assist in
further determining the problem.
System Logs or information on how to view logs.
The SNMP MIB Reference for information on associated status and alarm
conditions.
Verify that the Run/Fail LED is green. If so, the card is receiving power and
POST test results are positive. If it is off, the card is not receiving power.
Check the state of the Active LED. If it is green, the card is in active mode. This
is normal for the SPIO in slot 24 since the chassis automatically makes the card
active at boot up.
Troubleshooting
None needed.
NOTE: This LED will not indicate the presence of a network link until the
interface parameters are set during the software configuration process.
Troubleshooting