Cisco Catalyst 6000 WS-F6K-MSFC2 Hinweis zur Installation - Seite 7

Blättern Sie online oder laden Sie pdf Hinweis zur Installation für Netzwerk-Hardware Cisco Catalyst 6000 WS-F6K-MSFC2 herunter. Cisco Catalyst 6000 WS-F6K-MSFC2 18 Seiten. Catalyst 6000 series multilayer switch feature card 2

Seite drucken

Installation Guidelines

Follow these guidelines when installing an MSFC2 on a supervisor engine:

•

Preparing the Supervisor Engine

Note

Review the guidelines in the

supervisor engine.

To install the MSFC2 on a Supervisor Engine 1A with a PFC and an MSFC, you must shut down the

switch, remove the Supervisor Engine 1A from the chassis, and remove the MSFC from the

Supervisor Engine 1A.

To install the MSFC2 on a Supervisor Engine 2, you must shut down the switch and remove the

Supervisor Engine 2 from the chassis.

Always use an ESD wrist strap when handling modules or coming into contact with internal

Caution

components.

Before you remove a supervisor engine, you should first upload the current configuration to a server.

This saves time when bringing the module back online. You can recover the configuration by

downloading it from the server to the nonvolatile memory of the supervisor engine. For more

information, refer to Chapter 26, "Working with Configuration Files," in the Catalyst 6000 Family

Software Configuration Guide.

78-10605-03

The hardware on both supervisor engines in a single chassis must be identical. You cannot mix an

MSFC and an MSFC2 in the same chassis. You must shut down the switch to install the MSFC2,

even if you have redundant supervisor engines.

If you have redundant supervisor engines, you must install an MSFC2 on each supervisor engine.

The Supervisor Engine 1A with only a PFC cannot be upgraded to MSFC2. There are no standoffs

installed for securing the MSFC2 to the supervisor engine.

The Supervisor Engine 1A with a PFC and an MSFC (WS-X6K-SUP1A-MSFC) can be upgraded to

an MSFC2. You must remove the existing MSFC from the Supervisor Engine 1A. The MSFC2 uses

the same standoffs used for the MSFC.

The Supervisor Engine 2 with a PFC2 (WS-X6K-SUP2-2GE) can be upgraded to an MSFC2. The

supervisor engine has standoffs installed for securing the MSFC2 to the supervisor engine.

"Software Requirements" section on page 6

Catalyst 6000 Family Multilayer Switch Feature Card 2 Installation Note

Installation Guidelines

before you prepare the