Cisco Catalyst 8300 Series Hardware-Installationshandbuch - Seite 38

Blättern Sie online oder laden Sie pdf Hardware-Installationshandbuch für Netzwerk-Hardware Cisco Catalyst 8300 Series herunter. Cisco Catalyst 8300 Series 46 Seiten. Edge ucpe

Seite drucken

Installing Pluggable Interface Module

Table 1:

These are the steps to remove a NIM:

1. If the NIM is up and running, issue the following command to shut down the NIM gracefully before

removing it:

hw-module subslot slot 0/2 stop

Caution

2. Locate the NIM slot on the front panel.

3. Loosen the screws that secure the NIM.

4. Gently pull out the NIM from the slot.

All module slots must have a module or blank installed for the product to work thermally and for safety

purposes.

Installing Pluggable Interface Module

To insert the PIM into the router, do these steps:

1. Insert and then gently push the PIM into the pluggable slot until firmly fixed.

Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide

If you do not shut down the NIM gracefully before removing it, the NIM card could get damaged.

Install and Upgrade Field Replaceable Units

Screws

NIM face