Digitone ProSeries II Call Blocker Betriebshandbuch - Seite 2
Blättern Sie online oder laden Sie pdf Betriebshandbuch für Telefon-Zubehör Digitone ProSeries II Call Blocker herunter. Digitone ProSeries II Call Blocker 17 Seiten. Automatically blocks and routes screened calls using caller id with back lighted display
Seite drucken
Digitone ProSeries II Call Blocker
Thank you for choosing Digitone's ProSeries
Personal Telephony Management. The DPCB comes preloaded to block Millions of
Out of Area, Private, Anonymous, No Number, Exchanges and Trillions of Spoofed
Fake Names using Digitone's Patented matrix system. Just connect your Phones and
you're ready to go as Digitone's DPCB can operate right out of the box. No Battery
Backup is Needed. If a power outage occurs, all program settings remain intact.
Step 1. Connect the supplied line cord to your telephone Wall jack, or cable modem
Phone jack, or VoIP adapter's Phone jack and then to the Line Port on the DPCB.
Initially, "Connect to Line Service" will show on the display until the Line cord is
plugged into the LINE port. Note: "Connect to Line Service" will also backlight the
display if the Line cord is disconnected afterwards.
Step 2. Connect your Phone or Combo Phone System to the TEL phone port of the
DPCB and set to 3-5 rings. Before powering up the DPCB, take your phone Off-Hook to
see if you have a dial tone, if so hang-up. Note if you also have Voice Mail services
from your phone company, then set the Voice Mail Ring Count to 6 or 7 rings.
Step 3. Next, plug the small end of the Power Adapter into the port labeled 24VDC on
the DPCB, then plug in the Power Adapter into a standard AC receptacle. Your final
assembly should look like this figure below:
Call Blocker™ (DPCB) model for your
II
1
™