Cisco Firepower 4100 Series Handbuch - Seite 8
Blättern Sie online oder laden Sie pdf Handbuch für Netzwerk-Hardware Cisco Firepower 4100 Series herunter. Cisco Firepower 4100 Series 42 Seiten. Rack-mount and ground the chassis
Auch für Cisco Firepower 4100 Series: Produkthandbuch (17 seiten), Handbuch (8 seiten), Handbuch für Wartung und Aufrüstung (20 seiten), Handbuch (36 seiten), Handbuch (8 seiten), Handbuch (38 seiten)
Front Panel
Front Panel
The following figure shows the front panel of the Firepower 4100.
Figure 5: Firepower 4100 Front Panel
1
3
5
7
9
11
RJ-45 Console Port
Type A USB Port
Overview
8
RJ-45 console port
USB 2.0 Type A port
SSD 1
Reserved for the primary SSD; slot 1 must always
be populated.
Power LED
Pullout asset card
Network module 3
The 10-Gb network module is shown.
Note
The Firepower 4100 has a standard RJ-45 console port. You can use the CLI to configure your Firepower
4100 through the RJ-45 serial console port by using a terminal server or a terminal emulation program
on a computer.
The RJ-45 (8P8C) port supports RS-232 signaling to an internal UART controller. The console port does
not have any hardware flow control, and does not support a remote dial-in modem. The baud rate is 9600.
You can use the standard cable found in your accessory kit to convert the RJ-45 to DB-9 if necessary.
You can use the external USB Type A port to attach a data storage device. The external USB drive
identifier is
. The USB Type A port supports the following:
disk1:
• Hot swapping
2
Gigabit Ethernet management port
4
Eight fixed SFP+ (1-Gb/10-Gb) ports (in network
module slot 1)
Ethernet 1/1 through 1/8 labeled top to bottom,
left to right
6
SSD 2
Reserved for the optional MSP.
Locator LED
8
10
Network module 2
The 10-Gb network module is shown.
Note
Overview