Cisco IAD2430 Series Schnellstart-Handbuch - Seite 20
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Netzwerk-Hardware Cisco IAD2430 Series herunter. Cisco IAD2430 Series 34 Seiten. Integrated access device
Auch für Cisco IAD2430 Series: Übersicht Handbuch (13 seiten), Übersicht (16 seiten)
Seite drucken
• VWIC-2MFT-T1
• VWIC-2MFT-E1
Contact your Cisco account representative for the most recent, supported cards.
Note
For detailed information on installing and connecting interface cards, see the following URL:
http://www.cisco.com/en/US/products/hw/modules/ps2641/prod_installation_guides_list.html
Caution
WAN and voice interface cards do not support online insertion and removal (OIR, or hot swapping). Before
inserting a card into the Cisco IAD chassis, you must turn off electrical power and disconnect network cables.
Always use an ESD-preventive wrist strap when handling cards.
To install a WIC or VIC, follow these steps:
Use a number-2 Phillips screwdriver to remove the screws holding the metal plate over the card slot cover. Remove the
Step 1
plate.
Holding the interface card by the edges, line up the card with the guides on both sides of the slot.
Step 2
Insert the card in the slot. Push until it is firmly seated in the connector and the front panel of the card is flush with the
Step 3
back panel of the Cisco IAD.
Step 4
Use the screwdriver to tighten the captive screws on the card.
9
Connecting Cables
This section provides the procedure for connecting cables to your router.
Connecting LAN and Power Cables
Table 2 lists port connections and cables for connecting Cisco IAD2430 series routers. Figure 19 shows LAN, administrative
access, and power connections for the Cisco IAD2430 series IADs. Figure 20 shows the connections for the Cisco IAD2435 IAD.
Caution
The Cisco IAD2430 series chassis provides inputs for both AC and DC power. Design your installation to use only
one type of power. Do not use AC and DC power at the same time. If you do, the unit stops operating, and you
must reboot it with only a single power source.
Table 2
LAN, Administrative Access, and Power Cable Selection
Port or Connection
Color or Type Connected To
Fast Ethernet
Yellow
Console
Light blue
Auxiliary
Black
Power
Power
1. Power cables vary to meet local requirements.
20
Fast Ethernet hub
PC or ASCII terminal
communication (COM) port
Modem for remote access
100–240 VAC, 50–60 Hz
Cable
Straight-through Fast Ethernet cable (not included)
RJ-45-to-DB9 console cable (included)
RJ-45-to-DB25 auxiliary cable (included)
Grounding power cord (included)
1