Digitrax SE74 Handbuch - Seite 8

Blättern Sie online oder laden Sie pdf Handbuch für Medienkonverter Digitrax SE74 herunter. Digitrax SE74 12 Seiten.

Seite drucken

problems.

Note that the example 1st SE74 SN#3122 and 2nd SE74 SN#2399 sit

between the minimum SW 5 and maximum SW15 Base SW#'s to have no

overlaps with the first and second SE74's. This Switch 'gap' is because the 1st

SE74 only uses to Sw004, but its aspect number goes from head 1 to 16, so

any following SE74 has to have a Base Sw at 17 or above. The DS74's don't

use Aspect address ranges so can be arranged in this 'gap'.

10. Press "X" to exit any DT602 advanced mode.

11. This advanced DT602 capability allows you to setup all DS7x family device

combinations, like the SE74, DS78V, PM74 and SE74 etc, at installed posi-

tions on a LocoNet layout, quickly and conveniently, even if all devices are

initially at factory-default Base address SW1.

12. If you are using other types of non-DS7x family control devices, you will

have to note their active Base SW addresses/ranges and manually ensure the

SE74's are configured to not overlap these.

6.1 Reading and Editing a SE74's routes:

you have a suitable DT602 plugged into LocoNet, press the; Menu>3>4 keys to

enter Route Editor menu. If any SE74 is on LocoNet, the DT602 will beep after

about one second and show "DS7x" routes at the D soft key position.

Press the D soft key to now enter the

"Selecting DS7x device:" screen,

Rotate the LH encoder knob to under-

line the SE74 to edit routes for.

Now press DOWN the LH encoder knob

to read in and display the Routes of the

selected SE74, as shown in adjacent

"EDIT DS7X Rt#:" screen.

The LH encoder knob now selects a

Route# and the RH encoder selects the

black outlined Entry# to edit. Soft A key

will toggle the entry from T to C direc-

tion choice. Numeric keys will change

the SW# in the outlined Entry position.

"Add" soft key allows inserting another

entry at current position and "Delete"

will remove the current entry. The "SW

test" soft key will send just the outlined

switch# and direction to LocoNet.

After edit of any Route is complete be sure to press the "Save" soft key to

update this SE74 Route to non-volatile memory. Press "X" to exit.

With LocoNet connected SE74 routes have System wide control capability.

CS Rt

EDIT DS7x Rt#

Entry# TOP of 8

0100c

0224t

SE74

Sw0016+04 #0945

DS7X Edit: LH knob selects

Thrown

— 8 —

As for section 2.0, if

SW test

Delete

01 of 8

Add

Save