Digitrax SE8C Einbauanleitung

Blättern Sie online oder laden Sie pdf Einbauanleitung für Medienkonverter Digitrax SE8C herunter. Digitrax SE8C 2 Seiten. Breakout board

SE8c Breakout Board

Installation Instructions

The breakout board eliminates soldering connections to the card edge

or card edge adapter of a SE8c signal controller board.

Strip approximately .125" (1/8 inch) off your wire. Either solid or stranded wire can

be used, from 12\6 AWG to 26 AWG. Insert the bare portion of the wire into the ter

minal block and tighten the screw to make a solid connection.

Do not over-tighten,as

much force.

The instructions on the next page describe the board and connections

as if the large connector for the SE8c is at the top; matching the orientation of the

picture above.

12V to 18V AC or DC is connected to the board via the top left block.

Slow Motion Switch Machine Outputs:

Along the right side and right bottom edge of the board facing you are the 8 outputs for a slow mo

tion switch machine. The outputs start with switch machine 1, at the very top right. Each output is 2

terminal positions, so each large block has 4 outputs with 2 wire connections each. Each output is

labeled on the board (please note picture) as SM1, SM2 and so on.

Digitrax, PM42, BDL 168 and SE8c are property of Digitrax, Inc

Making Connections:

the terminal blocks can be stripped or broken with too

Power: