Digitrax DS78V Anleitung Handbuch - Seite 7

Blättern Sie online oder laden Sie pdf Anleitung Handbuch für Kontrollsysteme Digitrax DS78V herunter. Digitrax DS78V 8 Seiten. Eight servo loconet stationary/accessory decoder for turnout control.

Seite drucken

6.2 Reading and Editing a DS78V's routes:

using a suitable DT602 plugged into LocoNet, press the; Menu>3>4 keys to enter

Route Editor menu. If any DS78V is on LocoNet, the DT602 will beep after

about one second and show "DS7x" routes at the D soft key position.

Press the D soft key to now enter the

"Selecting DS7x device:" screen,

Rotate the LH encoder knob to under-

line the DS78V to edit routes for.

Now press DOWN the LH encoder knob

to read in and display the Routes of the

selected DS78V, as shown in adjacent

"EDIT DS7X Rt#:" screen.

The LH encoder knob now selects a

Route# and the RH encoder selects the

black outlined Entry# to edit. Soft A key

will toggle the entry from T to C direc-

tion choice. Numeric keys will change

the SW# in the outlined Entry position.

"Add" soft key allows inserting another

entry at current position and "Delete"

will remove the current entry. The "SW

test" soft key will send just the outlined

switch# and direction to LocoNet.

After edit of any Route is complete be sure to press the "Save" soft key to

update this DS78V Route to non-volatile memory. Press "X" to exit.

With LocoNet connected DS78V routes have System wide control ability.

6.3 Programming DS78V CVs on LocoNet:

with a suitable DT602, press the; Menu>2>1 keys to enter Operations Mode

programming.

Press the F "SWITCH" soft key to enter the "Ops Switch" mode program-

ming screen as shown adjacent. This

example screen shows CV11 selected for

a DS78V with BASE address of SW1.

Use the LH and RH encoder knobs to

select the SW#/ADR of the DS78V to

modify a CV on. A DS78V's CV11 to

CV15 access the 40 OPSW bit settings.

For example; press the "CVDATA" soft

key at CV11 to change to CV data entry,

press the number 6 then press "WRITE".

This now configures the 8 OPSW bits of

CV11 to 6, forcing this DS78V to change

to semaphore mode with eight 3-posi-

tion outputs. A value of 02 in CV11 sets

default 2-position mode.

Be careful changing the values in

CV11,12,13,14 and CV15 since the 8 bit

data number 0-255 in these CV's actu-

CS Rt

EDIT DS7X Rt#:

Entry#

TOP of 8

0100c

0224t

DS78V

DS7X Edit: LH knob selects

Thrown

CV Program Menu A:

Ops Switch ADR: 0001

CV Number:

CV data:

CVNUM

— 7 —

As for section 6.1,

SW test

Delete

01 of 16

Sw0009+8 # 3122

Add

Save

As for section 6.0,

LOCO

0011

0000

CVDATA

DONE