Digitrax DS74 Handbuch - Seite 7

Blättern Sie online oder laden Sie pdf Handbuch für Kontrolleinheit Digitrax DS74 herunter. Digitrax DS74 8 Seiten. Complete train control

Seite drucken

6.2 Reading and Editing a DS74's routes:

using a suitable DT602 plugged into LocoNet, press the; Menu>3>4 keys to enter

Route Editor menu. If any DS74 is on LocoNet, the DT602 will beep after about

one second and show "DS7x" routes at the D soft key position.

Press the D soft key to now enter the

"Selecting DS7x device " screen ,

Rotate the LH encoder knob to under-

line the DS74 to edit routes on,

Now press DOWN the LH encoder knob

to read in and display the Routes of the

selected DS74, as shown in adjacent

"EDIT DS7x Rt#" screen.

The LH encoder knob now selects a

Route# and the RH encoder selects the

black outlined Entry# to edit. Soft A key

will toggle the entry from T to C direc-

tion choice. Numeric keys will change

the SW# in the outlined Entry position.

"Add" soft key allows inserting another

entry at current position and "Delete"

will remove the current entry. The "SW

test" will send just the outlined switch#

and direction to LocoNet.

After edit of a Route is complete be sure to press the "Save" soft key to

update this in DS74 Route to non-volatile memory. Press "X" to exit.

6.3 Programming DS74 CVs on LocoNet:

a suitable DT602; press Menu>2>1 keys to enter Operations Mode programming.

Press the F "SWITCH" soft key to enter the "Ops Switch" mode program-

ming screen as shown adjacent. This

example screen shows CV11 selected for

a DS74 with BASE address of SW1.

Use the LH and RH encoder knobs to

select the SW# that you wish to modify

a CV on. DS74's CV11 to CV15 access the

40 OPSW bit settings.

For example; at CV11 press the "CV-

DATA" soft key to change to CV data

entry and press the number 5 then press

"WRITE" key. This now configures the

8 OPSW bits in CV11 to 5, forcing this

DS74 to change to Light mode with 8

on/off outputs. A value of 00 in CV11

will return to factory default Pulse-sole-

noid mode. A CV11 value 0f 01 sets Slow

motion output mode.

Be careful changing the values in

CS Rt

EDIT DS7x Rt#

Entry# TOP of 8

0100c

0224t

DS74

Sw0005+04# 3122

DS7X Edit: LH knob selects

Thrown

CV Program Menu A:

Ops Switch ADR: 0001

CV Number:

CV data:

CVNUM

— 7 —

As for section 6.0,

SW test

Delete

01 of 8

Add

Save

As for section 6.0, with

LOCO

0011

0000

CVDATA

DONE