Cisco PIX 506 Schnellstart-Handbuch - Seite 12

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Netzwerk-Hardware Cisco PIX 506 herunter. Cisco PIX 506 18 Seiten. Chapter 3
Auch für Cisco PIX 506: Benutzerhandbuch (8 seiten)

Seite drucken

Follow these steps to use an activation key:

Ensure that the image in Flash memory and the Running Image are the same.

Step 1

From the CLI, enter the activation-key activation-key-four-tuple command, replacing

Step 2

activation-key-four-tuple with the activation key obtained from Cisco.

Note

Make sure that you are in config mode to enter a new activation key.

Reboot the PIX Firewall by powering it off and then on again.

Step 3

After the key update is complete, the system reloads again to update the running image.

Restore the Default Configuration

Caution

Entering the config factory-default command erases the current running configuration.

If you inadvertently erase the default configuration or need to restore the default configuration, you

can restore the factory default values in one of the following ways:

• Run the Startup Wizard and click Reset PIX to Factory Default Configuration from the Starting

Configuration page.

• Use PDM and click File>Reset PIX to Factory Default Configuration.

• Use PDM or a terminal emulation program and enter the following commands:

Command

config factory-default [<inside ip

Step 1

address> [address mask]]

write memory

Step 2

If the optional inside IP address and optional address mask are specified, the factory-default configuration

will reflect the specified IP address.

Description

Erases the running configuration and replaces it with

the factory default configuration.

Writes the factory default configuration to Flash

memory.