Cisco RSP7000 Installation von - Seite 20

Blättern Sie online oder laden Sie pdf Installation von für Netzwerk-Hardware Cisco RSP7000 herunter. Cisco RSP7000 26 Seiten. Upgrade kit in the cisco 7000 series routers
Auch für Cisco RSP7000: Installations- und Konfigurationshandbuch (48 seiten)

Seite drucken

Installing the RSP7000 Upgrade Kit

Installing the RSP7000

The RSP7000 is keyed for installation only in the 7000 RSP slot (slot 5 in the Cisco 7000, see

Figure 1, and slot 3 in the Cisco 7010, see Figure 2).

Note

to Figure 7 for the Cisco 7010, both of which appear on page 10.

Follow these steps to install the RSP7000:

Step 1

Step 2

Caution

Cisco 7000 or slot 3 of the CIsco 7010. (See Figure 1 on page 2 or Figure 2 on page 3.) The slots are

keyed for correct installation. Forcing the 7000 RSP into a different slot can damage the backplane

and the RSP7000.

Step 3

Step 4

Step 5

Step 6

Step 7

20 Installing the RSP7000 Upgrade Kit in the Cisco 7000 Series Routers

For proper card orientation during this installation, refer to Figure 6 for the Cisco 7000 and

Grasp the RSP7000 handle with one hand and place your other hand under the carrier to

support as you guide it into the 7000 RSP slot in the following step. Avoid touching the

board or any connectors.

Place the back of the RSP7000 in the 7000 RSP slot, and align the notches along the edge

of the carrier with the grooves in the slot.

To prevent damage to the backplane, you must install the RSP7000 in slot 5 of the

While keeping the RSP7000 parallel to the backplane, carefully slide the carrier into the

7000 RSP until the RSP7000 faceplate makes contact with the ejector levers, then stop.

(See Figure 5b on page 9.)

Using the thumb and foreﬁnger of each hand to pinch each ejector, simultaneously push

both ejectors inward (toward the handle) until they parallel to the faceplate. (See Figure 5c

on page 9.)

Use a screwdriver (number 2 Phillips or 3/16-inch ﬂat-blade) to tighten the captive

installation screws on the ends of the RSP7000. (See Figure 5a on page 9.)

Tighten the two captive screws on the RSP7000 faceplate to prevent the RSP7000 from

becoming partially dislodged from the backplane and to ensure proper EMI shielding.

(These screws must be tightened to meet EMI speciﬁcations.)

Connect the console terminal to the console port and any auxiliary devices to the auxiliary

port on the RSP7000.

Ensure that the console terminal is turned on.