AcueLighting HALO Sport 100 Benutzerhandbuch - Seite 4
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Beleuchtungsanlagen AcueLighting HALO Sport 100 herunter. AcueLighting HALO Sport 100 12 Seiten.
Seite drucken
l
Prism: 3 prism
l
0-100% mechanical dimming, mechanical dimming and free dimming available.
l
Power Input: 100-240V，50/60Hz
l
Max Power Consumption: 200W
l
IP level: IP20
1.5 Cable connection (DMX)
Use a cable compliant to the specifications o f EIA RS-485: 2-pole twisted, shielded, 120 Ohm
characteristic impedance, 22-24 AWG. Do not use microphone cable or other cable with characteristics
differing from those specified. The end connections must be made using XLR type 3 pin male/female
connectors. A terminating plug must be inserted into the last fixture with a resistance of 120 Ohm (minimum
1/4 W) between terminals 2 and 3.
IMPORTANT: The wires must not make contact with each other or with the metal casing of the
connectors. The casing itself must be connected to the shield braid and to pin 1 of the connectors
(ground).
1.6 Rigging (Optional)
This equipment can be positioned and fixed by a clamp in any direction.
Attention! One clamp and one safety cable are needed to attach the equipment safely.
Attention! Fasten a safety cable to the eye-bolt hole under the fixture. The safety cable must never
be mounted to the handle or any other part of the fixture.
l
Check if the rigging bracket or clamps are damaged before every use. The mounting surface
must be able to withstand ten times the weight of the equipment. Make sure the structure and
mounting point can withstand ten times the weight of all the equipment installed in same
location.
Figure 1 DMX Cable connection