Cisco TelePresence ISDN Link Handbuch für Administratoren - Seite 10
Blättern Sie online oder laden Sie pdf Handbuch für Administratoren für Netzwerk-Hardware Cisco TelePresence ISDN Link herunter. Cisco TelePresence ISDN Link 27 Seiten. Isdn link
Seite drucken
Cisco TelePresence ISDN Link
Contents
Introduction
Connecting to the unit
The unit can be configured through the serial port or over the network.
Connect to the ISDN Link through the serial port
1. Use a standard serial cable and connect the cable between ISDN Link serial port and PC/laptop.
2. Use a terminal program to connect to the ISDN Link (115200, 8, 1, none)
3. Login as admin.
Connect to the ISDN Link over the network
When you know the IP Address of your ISDN Link unit an SSH over IP connection can be
established.
In order to find the IP address this is best done by using the serial port (See "Connect to the ISDN
Link through the serial port" on page 10above) and run the following command: xStatus
Network
1. Connect the network cable between ISDN Link Ethernet port and LAN network.
2. Use a PC/laptop connected to the same LAN network and open a command line interface, e.g.
PuTTY. Enter the IP Address and select Connection Type SSH.
3. Login as admin.
D14954.01
ISDN Link Administrator Guide IL1.0, June 2012.
Copyright © 2012 Cisco Systems, Inc. All rights reserved.
Getting started
Getting started
Configuration examples
Troubleshooting
Alarm status
Whenever the PWR LED turns red, it is an indication of something wrong, most likely causing
problems for normal use.
Checking the system unit status
Use the following command to get some basic indication of the problem:
In case of multiple errors, only the error with the highest priority is shown, and must be solved
before lower priority error is shown.
10
Password protection
xStatus SystemUnit State Status
Administrator guide
Appendices
Contact us
www.cisco.com