Cisco 2600 Series Anmerkungen zur Veröffentlichung - Seite 23

Blättern Sie online oder laden Sie pdf Anmerkungen zur Veröffentlichung für Server Cisco 2600 Series herunter. Cisco 2600 Series 32 Seiten. Configuring adsl wic to support pppoe clients
Auch für Cisco 2600 Series: Installationshandbuch (12 seiten), Konfiguration (15 seiten), Anwendungshinweis (41 seiten), Datenblatt (6 seiten), Anhang (15 seiten), Installationshandbuch (22 seiten), Übersicht (13 seiten), Schnellstart-Handbuch (2 seiten), Handbuch (5 seiten)

Step 23

Step 24

Step 25

After reload is complete, the router should be running the required Cisco IOS image. Use the

show version command to verify.

Related Documentation

This section describes documentation related to the Cisco 2600 series, typically including hardware

installation guides, software installation guides, Cisco IOS conﬁguration and command references,

system error messages, and feature modules that are updates to the Cisco IOS documentation set.

Documentation is available as printed manuals or electronic documents, except for the feature

modules, which are available online only.

The most up-to-date documentation can be found on the Web via Cisco Connection Online (CCO)

and on the latest Documentation CD-ROM. These electronic documents might contain updates and

modiﬁcations made after the paper documents were printed. See the "Obtaining Documentation"

section on page 29 for more information.

This section contains the following subsections:

•

Release-Speciﬁc Documents, page 24

•

Platform-Speciﬁc Documents, page 25

•

Feature Modules, page 25

•

Cisco IOS Documentation Set, page 26

Enter yes in response to the prompt asking if you want to erase the existing image copy

resident in the router Flash memory before copying the new one.

Erase flash device before writing? [confirm] yes

The entire copying process takes several minutes and differs from network to network.

The exclamation point (!) indicates that the copy process is taking place. Each

exclamation point (!) indicates that ten packets have been transferred successfully. A

checksum veriﬁcation of the image occurs after the image is written to Flash memory.

Enter the following commands to reset the conﬁguration register to 0x2102.

Router(boot)(config)# config terminal

Router(boot)(config)# config-reg 0x2102

Router(boot)(config)# end

Enter the reload command to reload the router:

Router# reload

Release Notes for Cisco IOS Release 12.0(7)XK1 Feature Packs for Cisco 2600 Series Routers