Cisco 2600 Series Konfiguration - Seite 10

Blättern Sie online oder laden Sie pdf Konfiguration für Server Cisco 2600 Series herunter. Cisco 2600 Series 15 Seiten. Configuring adsl wic to support pppoe clients
Auch für Cisco 2600 Series: Installationshandbuch (12 seiten), Anmerkungen zur Veröffentlichung (32 seiten), Anwendungshinweis (41 seiten), Datenblatt (6 seiten), Anhang (15 seiten), Installationshandbuch (22 seiten), Übersicht (13 seiten), Schnellstart-Handbuch (2 seiten), Handbuch (5 seiten)

Seite drucken
Cisco 2600 Series Konfiguration
area
auto-cost
capability
compatible
default
default-information
default-metric
discard-route
distance
distribute-list
domain-id
domain-tag
exit
help
ignore
log-adjacency-changes
maximum-paths
neighbor
network
no
passive-interface
redistribute
router-id
summary-address
timers
traffic-share
The network-number identifies the network using OSPF. The mask tells which bits to
use from the network-number, and the area-id is used for determining areas in an OSPF
configuration. For example:
Router(config-router)#network 10.12.0.4 255.255.255.252 area 0
Area 0 is so called backbone network.

2.2.2 Router ID

Router ID is the tie-breaker for OSPF path selection. The path selection process uses a
variety of metrics to select a route. If all other metrics (accessibility, administrative
weight, local preference, etc.) are equal, OSPF determines the router ID using the
following priority:
1. Use the address configured by the ospf router-id command
2. Use the address of the loopback 0 interface
3. Use the highest IP address of any interface
4. If no interface exists, set the router-ID to 0.0.0.0
OSPF area parameters
Calculate OSPF interface cost according to
bandwidth
Enable specific OSPF feature
OSPF compatibility list
Set a command to its defaults
Control distribution of default information
Set metric of redistributed routes
Enable or disable discard-route installation
Define an administrative distance
Filter networks in routing updates
OSPF domain-id
OSPF domain-tag
Exit from routing protocol configuration mode
Description of the interactive help system
Do not complain about specific event
Log changes in adjacency state
Forward packets over multiple paths
Specify a neighbor router
Enable routing on an IP network
Negate a command or set its defaults
Suppress routing updates on an interface
Redistribute information from another routing
protocol
router-id for this OSPF process
Configure IP address summaries
Adjust routing timers
How to compute traffic share over alternate
paths
10