Cisco 7513 Series Anleitung zum Ersetzen Handbuch - Seite 19

Blättern Sie online oder laden Sie pdf Anleitung zum Ersetzen Handbuch für Server Cisco 7513 Series herunter. Cisco 7513 Series 22 Seiten. Chassis replacement
Auch für Cisco 7513 Series: Schnellstart-Handbuch (44 seiten), Anleitung zum Ersetzen Handbuch (26 seiten), Datenblatt (11 seiten), Handbuch (30 seiten), Pflege von (20 seiten), Anleitung zum Ersetzen Handbuch (19 seiten)

When the system starts up and operates successfully, the replacement procedure is complete, and

you can resume normal operation.

If the system still fails to start up or operate properly, or if you isolate the cause of the problem to a

failed component, contact a service representative for further assistance.

Note

parts. If the old chassis is still mounted in a rack, follow the steps in the section "Removing the

Existing Chassis from the Rack" on page 9 to remove it. Place spare interface processors or interface

processor ﬁllers in the chassis slots, and move the chassis to the appropriate location for storage or

shipment.

Verifying the Installation Using show Command Descriptions and Examples

This section describes the various show commands that you can use to display system status and

conﬁguration. If you installed the interface processors in the same slot locations that they occupied

in the old chassis, the interfaces should retain the same conﬁguration. If you installed the interface

processors in different slot locations, the system will recognize the interfaces, but you will have to

use the conﬁgure command to reconﬁgure and enable them.

You can check the version of the default ROM image either by removing the board and checking the

ROM labels or by conﬁguring the interface or system software to boot from ROM, restarting the

system, and using these same commands to check the running version.

Use the show version command to display the current system software version, and use the show

controllers cxbus command to display the microcode version of the SP and each interface

processor. In the following example of the show version command, the system software is

Release 10.3(571)).

Router> show version

GS Software (RSP-K), Version 10.3(571), SOFTWARE

Compiled Wed 10-May-95 14:46 by mpo

System Bootstrap, Version 4.6(1) [fc2], SOFTWARE

Current date and time is Sat 1-22-1994 21:38:35

Boot date and time is Tue 12-28-1993 15:32:28

Router uptime is 3 weeks, 4 days, 6 hours, 7 minutes

System restarted by reload

System image file is "gs7-k.103-1", booted via tftp from 1.1.1.12

(example text omitted

X.25 software, Version 2.0, NET2 and BFE compliant.

Bridging software.

1 EIP controller (6 Ethernet).

1 TRIP controller (4 Token Ring).

6 Ethernet/IEEE 802.3 interfaces.

4 Token Ring/IEEE 802.5 interfaces.

(remainder of example text omitted)

After you verify a successful installation, gather the old chassis and any remaining spares and

Cisco 7513 Chassis Replacement Instructions

Replacing the Chassis