Cisco C480M5 Handbuch zur Installation - Seite 10

Blättern Sie online oder laden Sie pdf Handbuch zur Installation für Server Cisco C480M5 herunter. Cisco C480M5 19 Seiten.

Reversing the Cable Management Arm (Optional)

Step 5

Open the hinged flap at the top of each plastic cable guide and route your cables through the cable guides as desired.

Reversing the Cable Management Arm (Optional)

Step 1

Rotate the entire CMA assembly 180 degrees, left-to-right. The plastic cable guides must remain pointing upward.

Step 2

Flip the tabs at the ends of the CMA arms so that they point toward the rear of the server.

Step 3

Pivot the tab that is at the end of the width-adjustment slider. Depress and hold the metal button on the outside of the tab

and pivot the tab 180 degrees so that it points toward the rear of the server.

Figure 6: Reversing the CMA

CMA tab on end of width-adjustment slider

Note

This section describes how to power on the server, assign an IP address, and connect to server management

when using the server in standalone mode. To use the server in Cisco UCS Manager integration, specific

cabling and settings are required. See

Installing the Server

Metal button on outside of tab

Installation For Cisco UCS Manager

Installing the Server

Integration.