Cisco Firepower Management Center 1500 Handbuch "Erste Schritte - Seite 17
Blättern Sie online oder laden Sie pdf Handbuch "Erste Schritte für Server Cisco Firepower Management Center 1500 herunter. Cisco Firepower Management Center 1500 42 Seiten. Firepower management center
Seite drucken
Table 1
Default Access Control Policy Applied Per Detection Mode
Detection Mode
Inline
Passive
Access Control
Network Discovery
An exception occurs if you previously managed a device with a Management Center and you changed the device's
initial interface configuration. In this case, the policy applied by this new Management Center page depends on
the changed (current) configuration of the device. If there are interfaces configured, the Management Center
applies the Default Intrusion Prevention policy. Otherwise, the Management Center applies the Default Access
Control policy.
If a device is incompatible with an access control policy, the policy apply fails. This incompatibility could occur for
multiple reasons, including licensing mismatches, model restrictions, passive vs inline issues, and other
misconfigurations. If the initial access control policy apply fails, the initial network discovery policy apply also fails.
After you resolve the issue that caused the failure, you must manually apply access control and network discovery
policies to the device. For more information about issues that could cause access control policy apply to fail, see
the Firepower Management Center Configuration Guide.
To add a device, type its
device. Remember this is a simple key that you specified, up to 37 characters in length, and is not the same as a
license key.
Then, use the check boxes to add licensed capabilities to the device. You can only select licenses you have already
added to the Management Center; see
Not all licenses are supported on all managed devices. However, the setup page does not prevent you from
enabling unsupported licenses on managed devices, or enabling a capability for which you do not have a
model-specific license. This is because the Management Center does not determine the device model until later.
The system cannot enable an invalid license, and attempting to enable an invalid license does not decrement your
available license count.
After you enable licenses, click
you selected the wrong options or mis-typed a device name, click
device.
End User License Agreement
Read the EULA carefully and, if you agree to abide by its provisions, select the check box. Make sure that all
the information you provided is correct, and click
The Management Center is configured according to your selections. You are logged into the web interface as
the
user, which has the Administrator role. Continue with step
admin
Centers, page 13
Administration Recommendations
After you complete the initial setup process for an appliance and verify its success, Cisco recommends that you
complete various administrative tasks that make your deployment easier to manage. You should also complete any
tasks you skipped during the initial setup, such as device registration and licensing. For detailed information on
any the tasks described in the following sections, as well as information on how you can begin to configure your
deployment, see the Firepower Management Center Configuration Guide for your software version.
Cisco Firepower Management Center Getting Started Guide
Default Access Control Policy
Default Intrusion Prevention
Default Intrusion Prevention
Default Access Control
Default Network Discovery
or
, as well as the
Hostname
IP Address
License Settings, page
Add
to save the device's registration settings and, optionally, add more devices. If
to complete the initial setup of the Management Center.
you specified when you registered the
Registration Key
15.
to remove it. You can then re-add the
Delete
Apply
.
3.
in
Initial Setup Page: Management
Administration Recommendations
17