Cisco MC750 Handbuch "Erste Schritte - Seite 4

Blättern Sie online oder laden Sie pdf Handbuch "Erste Schritte für Server Cisco MC750 herunter. Cisco MC750 42 Seiten. Firepower management center
Auch für Cisco MC750: Anleitung Handbuch (20 seiten)

Seite drucken

—

If your FMC is running Firepower Version 6.5+, this gives you access to the FMC CLI. To access the Linux

shell, continue with Step 2.

To access the Linux shell form the FMC CLI, enter the expert command.

Installation and Initial Setup for Versions 6.5+

Note:

Firepower Versions 6.5+ are not supported on FMC models 750, 1500, and 3500.

The first time you log into the FMC running Versions 6.5+, an Initial Configuration Wizard guides you through

configuring the new appliance to communicate on your trusted management network. The wizard presents a

streamlined initial configuration process and automatically establishes some weekly maintenance activities to

keep your system up-to-date and your data backed up.

The FMC management interface is pre-configured to accept an IPv4 address assigned by the Dynamic Host

Configuration Protocol (DHCP). If the FMC fails to obtain a DHCP lease, the management interface uses a fallback

IPv4 address of 192.168.45.45.

Note:

If you are connecting to an FMC for the first time after performing a System Restore and you chose to retain

license and network settings, the management interface IP address is the same as it was before you performed

the System Restore. Proceed directly to

To install and set up an FMC running Versions 6.5+:

Install the appliance as described in

To perform the initial setup you have one of two choices:

—

If your network does not use DHCP and your PC cannot reach the fallback address (or the address retained

in a System Restore), we recommend you perform the initial setup by connecting a computer directly to

the FMC's physical management interface as described in

Using the Management Interface, page

—

If your local DHCP will assign an address to the FMC, use a keyboard and monitor to set up the appliance;

see

Access the Firepower Management Center Using a Keyboard and Monitor, page

Install the Appliance

These instructions are an abbreviated version of the steps to physically install the appliance. For detailed

instructions, see the Cisco Firepower Management Center 750, 1500, 2000, 3500, and 4000 Hardware Installation

Guide.

Procedure

Mount the appliance in your rack using the mounting kit and its supplied instructions.

Attach power cords to both power supplies and plug them into separate power sources.

If you do not connect both power supplies, an amber warning indicator lights on the chassis front panel and

the FMC web interface displays a health alert.

Turn on the appliance by pressing the power switch located on the front panel.

After you press the power switch the appliance may turn on briefly and then appear to shut down with the

exception of the amber power indicator light on the chassis front panel. This is normal; pressing the power

button again causes the appliance to power up with the power indicator light green.

Cisco Firepower Management Center Getting Started Guide

Firepower Management Center Initial Configuration Wizard, page

Install the Appliance, page

Installation and Initial Setup for Versions 6.5+

Access the Firepower Management Center