B2 Audio MANI 600D21 Benutzerhandbuch - Seite 7
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken B2 Audio MANI 600D21 herunter. B2 Audio MANI 600D21 12 Seiten.
Seite drucken
SPEAKER CONNECTION
mani 600
SPEAKER IMPEDANCE 2 OHM ~ 8 OHM
will reach thermal at a faster rate & will eventually go into protect.
Impedance load under 2 ohm is not warranted!
We recommend using minumum12 Ga speaker cables to acquire the intended performance & e ciency.
Run the speaker cables from your speakers to the ampli er's mounting location.
Ensure these are ran separately and away from high current cables and if possible the RCA cables as well.
In all cases where cables are penetrating the vechile's chassis use grommets to protect the cable.
Connect the speaker wires according to the terminals on the speaker(s). Strip 3/8'' / 1 cm of insulation of the end of
each cable and twist the cable strands together tightly. Make sure there are no stray strands that could touch other
cables or terminals as it can cause a short circut. Crimp spade plugs over the end of the cable, or tin the ends with solder
to provide a solid terminal. Connect the cable ends to the ampli er as shown in the diagram.
Bridged speaker connection will add the 2 channels to a single channel. If all channels are bridged, the Mani 600.4
will then become a 2 channel ampli er. If only one pair is bridged, then the ampli er will become a 3 channel.
Setting the CH switch accordingly to the speaker con guration mode, provides a signal output to all channels from a pair
of RCA inputs. Bridged load is minimum 4 ohm for the Mani 600.4.
16 V
7
mani 600.4
SPEAKER IMPEDANCE 2 OHM ~ 8 OHM
will reach thermal at a faster rate & will eventually go into protect.
Impedance load under 2 ohm is not warranted!