Cisco SNS-3415 series Handbuch zur Installation - Seite 11
Blättern Sie online oder laden Sie pdf Handbuch zur Installation für Server Cisco SNS-3415 series herunter. Cisco SNS-3415 series 19 Seiten. Sns-3400 series
Auch für Cisco SNS-3415 series: Installationshandbuch (36 seiten), Handbuch zur Fehlersuche (8 seiten)
Seite drucken
Chapter 8
Installing the Cisco SNS 3415 and Cisco SNS 3495 Hardware Appliances
Equipment racks and enclosures house more equipment today than ever before. This growth has
increased the need for organized cable management both inside and outside the rack. Poor cable
management not only leads to damaged cables or increased time for adding or changing cables, but also
blocks critical airflow or access. These problems can lead to inefficiencies in the performance of your
equipment or even downtime.
There are many solutions to address cable management. They can range from simple cable management
rings, to vertical or horizontal organizers, to troughs and ladders.
All Cisco SNS-3415 or Cisco SNS-3495 appliance cables should be properly dressed so as not to
interfere with each other or other pieces of equipment. Use local practices to ensure that the cables
attached to your appliance are properly dressed.
Proceed to the next section,
page
Connecting and Powering On the Cisco SNS-3415/3495
Appliance
•
•
•
Connecting and Powering On the Server (Standalone Mode)
This section describes how to power on the server, assign an IP address, and connect to server
Note
management when using the server in standalone mode. To use the server in UCS integration, specific
cabling and settings are required. See
The server is shipped with a default NIC mode called Shared LOM, default NIC redundancy is
Note
active-active, and DHCP is enabled. Shared LOM mode enables the two 1-Gb Ethernet ports to access
the Cisco Integrated Management Interface (CIMC). If you want to use the 1-Gb Ethernet dedicated
management port, or a port on a Cisco UCS P81E Virtual Interface Card (VIC) to access the CIMC, you
must first connect to the server and change the NIC mode as described in Step 3 of the following
procedure. In that step, you can also change the NIC redundancy and set static IP settings.
Use the following procedure to perform initial setup of the server:
Attach a supplied power cord to each power supply in your server, and then attach the power cord to a
Step 1
grounded AC power outlet. See the
approximately two minutes to let the server boot in standby power during the first bootup.
You can verify power status by looking at the Power Status LED (see ):
•
Connecting and Powering On the Cisco SNS-3415/3495 Appliance,
8-11, to continue the installation process.
Connecting and Powering On the Server (Standalone Mode), page 8-11
System BIOS and CIMC Firmware, page 8-13
Service Headers and Jumpers, page 8-14
Off—There is no AC power present in the server.
Connecting and Powering On the Cisco SNS-3415/3495 Appliance
Installation for Cisco UCS
Power Specifications
Installation and Upgrade Guide for Cisco Secure Access Control System 5.6
Integration.
for power specifications. Wait for
8-11