Cisco SNS-3515-K9 Installation der Software - Seite 33
Blättern Sie online oder laden Sie pdf Installation der Software für Server Cisco SNS-3515-K9 herunter. Cisco SNS-3515-K9 38 Seiten.
Auch für Cisco SNS-3515-K9: Installationshandbuch (36 seiten)
Seite drucken
Install Cisco ISE Software on Cisco SNS Appliances
Note
It is not recommended to attempt offline installation of Cisco ISE as this can lead to system instability. When
you run the Cisco ISE installation script offline, the following error is shown:
Sync with NTP server failed' Incorrect time could render the system unusable until it is re-installed.
Retry? Y/N [Y]:
Choose Yes to continue with the installation. Choose No to retry syncing with the NTP server.
It is recommended to establish network connectivity with both the NTP server and the DNS server while
running the installation script.
To run the setup program:
Step 1
Turn on the appliance that is designated for the installation.
The setup prompt appears:
Please type 'setup' to configure the appliance
localhost login:
Step 2
At the login prompt, enter setup and press Enter.
The console displays a set of parameters. You must enter the parameter values as described in the table that follows.
Table 1: Cisco ISE Setup Program Parameters
Prompt
Hostname
(eth0) Ethernet interface address
Netmask
Default gateway
Description
Must not exceed 15 characters. Valid
characters include alphanumerical
(A–Z, a–z, 0–9), and the hyphen (-).
The first character must be a letter.
Note
We recommend that you use
lowercase letters to ensure
that certificate
authentication in Cisco ISE
is not impacted by minor
differences in
certificate-driven
verifications. You cannot
use "localhost" as hostname
for a node.
Must be a valid IPv4 address for the
Gigabit Ethernet 0 (eth0) interface.
Must be a valid IPv4netmask.
Must be a valid IPv4 address for the
default gateway.
Install Cisco ISE Software on Cisco SNS Appliances
Run the Setup Program
Example
isebeta1
10.12.13.14
255.255.255.0
33