Cisco UCS B200 M3 Installations- und Wartungshinweise - Seite 24

Blättern Sie online oder laden Sie pdf Installations- und Wartungshinweise für Server Cisco UCS B200 M3 herunter. Cisco UCS B200 M3 37 Seiten. Blade server
Auch für Cisco UCS B200 M3: Installationshandbuch (34 seiten), Installations- und Wartungshinweise (36 seiten), Handbuch (8 seiten), Upgrade-Handbuch (21 seiten), Installations- und Wartungshinweise (28 seiten)

Figure 17: Thermal Grease Application Pattern

Step 10

Replace the heat sink. See callout 4.

Caution

On certain models, heat sinks are keyed to fit into the plastic baffle extending from the motherboard. Do not

force a heat sink if it is not fitting well, rotate it and re-orient the heat sink.

Step 11

Secure the heat sink to the motherboard by tightening the four captive screws a quarter turn at a time in an X pattern as

shown in the upper right.

Memory and Performance

Installing Memory

To install a DIMM into the blade server, follow these steps:

Procedure

Step 1

Press the DIMM into its slot evenly on both ends until it clicks into place.

DIMMs are keyed, if a gentle force is not sufficient, make sure the notch on the DIMM is correctly aligned.

Be sure that the notch in the DIMM aligns with the slot. If the notch is misaligned you may damage the DIMM,

Note

the slot, or both.

Step 2

Press the DIMM connector latches inward slightly to seat them fully.

Supported DIMMs

The DIMMs supported in this blade server are constantly being updated. A list of currently supported and available DIMMs is in the

specification sheets at:

http://www.cisco.com/en/US/products/ps10280/products_data_sheets_list.html