Cisco UCS B200 M4 Wartungshandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Wartungshandbuch für Server Cisco UCS B200 M4 herunter. Cisco UCS B200 M4 24 Seiten. For e5-2600 v4 series cpus
Auch für Cisco UCS B200 M4: Installations- und Wartungshinweise (30 seiten), Installations- und Wartungshinweise (46 seiten), Upgrade-Handbuch (9 seiten)

Diagnostics Button and LEDs

Note

When the storage module is installed, the USB connector is underneath it. Use the small cutout opening in

the storage module to visually determine the location of the USB connector when you need to insert it.

Diagnostics Button and LEDs

At blade start-up, POST diagnostics test the CPUs, DIMMs, HDDs, and rear mezzanine modules, and any

failure notifications are sent to Cisco UCS Manager. You can view these notifications in the Cisco UCS

Manager System Error Log or in the output of the show tech-support command. If errors are found, an amber

diagnostic LED also lights up next to the failed component. During run time, the blade BIOS and component

drivers monitor for hardware faults and will light up the amber diagnostic LED as needed.

LED states are saved, and if you remove the blade from the chassis the LED values will persist for up to 10

minutes. Pressing the LED diagnostics button on the motherboard causes the LEDs that currently show a

component fault to light for up to 30 seconds for easier component identification. LED fault values are reset

when the blade is reinserted into the chassis and booted, and the process begins from its start.

If DIMM insertion errors are detected, they may cause the blade discovery process to fail and errors will be

reported in the server POST information, which is viewable using the UCS Manager GUI or CLI. DIMMs

must be populated according to specific rules. The rules depend on the blade server model. Refer to the

documentation for a specific blade server for those rules.

Faults on the DIMMs or rear mezzanine modules also cause the server health LED to light solid amber for

minor error conditions or blinking amber for critical error conditions.

Servicing a Blade Server

USB connector

An internal USB 2.0 port

is supported. A 16 GB

USB drive

(UCS-USBFLSHB-16GB)

is available from Cisco. A

clearance of 0.950 inches

(24.1 mm) is required for

the USB device to be

inserted and removed.

Front heat sink and CPU

Rear heat sink and CPU 2

Trusted Platform Module

(TPM)

Adapter slot 1

Servicing a Blade Server

DIMM slots

CPU heat sink install

guide pins

CMOS battery

DIMM diagnostic LED

button

Adapter slot 2