Cisco UCS B260 M4 Installations- und Wartungshinweise - Seite 14
Blättern Sie online oder laden Sie pdf Installations- und Wartungshinweise für Server Cisco UCS B260 M4 herunter. Cisco UCS B260 M4 46 Seiten. Blade server
Auch für Cisco UCS B260 M4: Installations- und Wartungshinweise (50 seiten)
Seite drucken
Buttons
LED
Health
(Disk Drive)
Buttons
The Reset button is recessed in the front panel of the server. You can press the button with the tip of a paper
clip or a similar item. Hold the button down for five seconds, and then release it to restart the server if other
methods of restarting do not work.
The locator function for an individual server may get turned on or off by pressing the locator button/LED.
The front-panel power button is disabled by default. It can re-enabled through Cisco UCS Manager. After it's
enabled, The power button allows you to manually take a server temporarily out of service but leave it in a
state where it can be restarted quickly. If the desired power state for a service profile associated with a blade
server is set to "off," using the power button or Cisco UCS Manager to reset the server will cause the desired
power state of the server to become out of sync with the actual power state and the server may unexpectedly
shut down at a later time. To safely reboot a server from a power-down state, use the Boot Server action in
Cisco UCS Manager.
Local Console Connection
The local console connector allows a direct connection to a blade server to allow operating system installation
and other management tasks to be done directly rather than remotely. The port uses the KVM dongle cable
that provides a connection into a Cisco UCS blade server; it has a DB9 serial connector, a VGA connector
for a monitor, and dual USB ports for a keyboard and mouse. With this cable, you can create a direct connection
Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v4 CPUs
6
Color
Description
Off
Can mean either no fault detected or the drive is not
installed.
Flashing Amber
Rebuild drive active.
4 hz
If the Activity LED is also flashing amber, a drive rebuild
is in progress.
Amber
Fault detected.
Overview