Cisco UCS B440 Installations- und Wartungshinweise - Seite 18

Blättern Sie online oder laden Sie pdf Installations- und Wartungshinweise für Server Cisco UCS B440 herunter. Cisco UCS B440 33 Seiten. High performance blade server

Seite drucken

Cisco UCS B440 Installations- und Wartungshinweise

topicWorking Inside the Blade Server

S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m

LED states are saved, and if you remove the blade from the chassis the LED values will persist for up to

10 minutes. Pressing the LED diagnostics button on the motherboard will cause the LEDs that currently

show a component fault to light for up to 30 seconds for easier component identification. LED fault

values are reset when the blade is reinserted into the chassis and booted, and the process begins from its

start.

If DIMM insertion errors are detected, they may cause the blade discovery to fail and errors will be

reported in the server POST information, viewable using the UCS Manager GUI or CLI. UCS blade

servers require specific rules to be followed when populating DIMMs in a blade server, and the rules

depend on the blade server model. Refer to the documentation for a specific blade server for those rules.

HDD status LEDs are on the front face of the HDD. Faults on the CPU, DIMMs, or adapter cards will

also cause the server health LED to light solid Amber for minor error conditions or blinking Amber for

critical error conditions.

topicWorking Inside the Blade Server

This section describes how to perform the following tasks within a blade server:

•

Installing a Motherboard CMOS Battery

This server supports the following Cisco components and part numbers.

Supported Components

CR2032 battery

Warning

There is danger of explosion if the battery is replaced incorrectly. Replace the battery only with the

same or equivalent type recommended by the manufacturer. Dispose of used batteries according to

the manufacturer's instructions.

Statement 1015

To install or replace a motherboard complementary metal-oxide semiconductor (CMOS) battery, follow

these steps:

Remove a motherboard CMOS battery:

Step 1

Cisco UCS B440 High Performance Blade Server Installation and Service Note

Installing a Motherboard CMOS Battery, page 18

Removing a CPU or Heat Sink, page 20

Installing a CPU or Heat Sink, page 22

Installing an Adapter Card, page 27

Installing a RAID License Key, page 28

Installing a RAID Battery Backup Unit (BBU), page 29