Digitus DC-KVS-14 Benutzerhandbuch - Seite 2

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Medienkonverter Digitus DC-KVS-14 herunter. Digitus DC-KVS-14 2 Seiten.

Seite drucken

Installation

1. Turn off the PC and monitors.

2. Connect the HD-15 video extension cable between the

PC and the "video in" port of splitter.

3. Connect the HD-15 video extension cables between the

monitors and the "video out" ports of splitter.

4. Connect the power cord and turn on the splitter.

5. Turn on the PC and monitors.

Note:

 If you install the DDC monitor for the splitter, the rest of

monitors must be the same resolution as the DDC

monitor.

 Available monitors include the VGA, SVGA, XGA,

QXGA,UXGA, Multisync, and exclude the CGA, EGA,

Mono.

Operation for cascade:

1. The function to display identical image on more monitors,

you request to attach another splitter.

2. Connect the HD-15 male/male video extension cable

between the "video out" port of the former splitter and

the "video in" port of the latter splitter.

Note:

Even though you are allowed to cascade the splitter with

varied ports, the image might become unstable if cascade

too many tiers of splitters.

P.S.: The example cascades the 2 and 4 ports splitters;

however, you can cascade the video splitter with

demanded port.

Note:

In the event of incorrect installation and improper use in a

residential area, the device may cause disruptions in radio

devices and other electronic devices. Proper use means

that the device is operated with shielded connector cables

as far as possible, for network products also with shielded

cables of category 5e and higher. The device was tested

and lies within the limits for computer accessories of class A

according to the requirements of EN 55022.

Warning !

This is a class A device. This device can cause radio

interference in residential areas; in this case, the operator

may be required to perform and bear the costs for

appropriate measures.

Conformity Declaration:

The device fulfils the EMC requirements of EN 55022 class

A for ITE and EN 55024. Devices with external or built-in

power supply also fulfil the requirements of EN 61000-3-2

and EN 61000-3-3. The basic protection requirements of

the "EMC Directive" 89/336/EEC are therefore fulfilled. The

CE conformity has been certified. The corresponding

declarations are available from the manufacturer.

Trademarks:

All company, brand and product names used in these

instructions are trademarks or registered marks of the

corresponding companies.