Digitus DN-16082-1 Benutzerhandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Sicherheitskamera Digitus DN-16082-1 herunter. Digitus DN-16082-1 17 Seiten. 4mp wdr rugged dome ip camera

Seite drucken

1. Access Camera

Camera Cabling

Before users connect cables, make sure that all cables and the power adaptor

are placed in dry and well-waterproofed environments, e.g. waterproof boxes.

The purpose is to prevent moisture accumulation inside the camera and

moisture penetration into cables, which might lead to device breakdown. Please

refer to the following sections for camera connection.

2.1

Connect Power

For power connection, please refer to section Connectors. Alternatively, users

can power the camera by PoE if a Power Sourcing Equipment (PSE) switch is

available. Please refer to the section below for Ethernet cable connection.

2.2

Connect Ethernet Cable

To have best transmission quality, cable length shall not exceed 100 meters.

Connect one end of the Ethernet Cable to the RJ-45 connector of the camera,

and plug the other end of the cable to the network switch or PC.

Check the status of the link indicator and activity indicator LEDs. If the LEDs are

unlit, please check the LAN connection.

2.3

Connect Alarm I/O

The camera supports one alarm input and one relay output for alarm application.

Refer to section

NOTE: If PoE is used, make sure PSE is in use in the network.

NOTE: In some cases, Ethernet crossover cable might be needed when

connecting the IP camera directly to PC.

Green Link Light indicates good network connection.

Orange Activity Light flashes for network activity indication.

Connectors

for pin definitions.