Cisco DPC3848VM Benutzerhandbuch - Seite 32
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Gateway Cisco DPC3848VM herunter. Cisco DPC3848VM 50 Seiten. Docsis 3.0 24x8 wireless residential gateway
Seite drucken
Chapter 2 Installing the D OC SIS 3.0 W ireless Residential Gateway
Connect the Wireless Residential Gateway
The following installation procedure ensures proper setup and configuration for the
residential gateway.
Choose an appropriate and safe location to install the residential gateway (close
1
to a power source, an active cable connection, your PC-if using high-speed
Internet, and your telephone lines-if using VoIP). For assistance, refer to Where Is
the Best Location for My Wireless Residential Gateway? (on page 11). For a
MoCA installation, also see Recommended MoCA Installation Guidelines (on
page 18).
Power off your PC and other networking device; then, unplug them from the
2
power source.
3
Connect the active RF coaxial cable from your service provider to the coax
connector labeled CABLE on the back of the residential gateway.
Note: To connect a TV, DHCT, set-top, or VCR from the same cable connection,
you will need to install a cable signal splitter (not included). Always check with
your service provider before using a splitter as a splitter may degrade the signal.
For more information about a MoCA installation, see MoCA Installation
Guidelines (on page 18).
Connect your PC to the residential gateway using one of the following methods:
4
Ethernet Connection. Connect one end of an Ethernet cable to the Ethernet
port on your PC, and connect the other end to the Ethernet port on the back
of the residential gateway.
Wireless Connection. Make sure that your wireless device is powered up.
You will need to associate your wireless device with the residential gateway
once the residential gateway is operational. Follow the directions provided
with your wireless device for associating with a wireless access point. Make
sure that either the 2.4G or the 5G indicator is ON.
16
WARNING:
To avoid personal injury, follow the installation instructions in the exact
order shown.
Wiring and connections must be properly insulated to prevent electrical
shock.
Disconnect power from the residential gateway before attempting to
connect to any device.
OL-30544-01