Cisco Physical Access CIAC-GW-K9 Installieren und Konfigurieren - Seite 12
Blättern Sie online oder laden Sie pdf Installieren und Konfigurieren für Gateway Cisco Physical Access CIAC-GW-K9 herunter. Cisco Physical Access CIAC-GW-K9 26 Seiten. Physical access gateway
Auch für Cisco Physical Access CIAC-GW-K9: Schnellstart-Handbuch (17 seiten)
Seite drucken
Installing the Cisco Physical Access Gateway
Figure 2-8
1
2
Connect optional expansion modules to the Gateway, if necessary:
Step 6
Insert a three-pin connector plug into the CAN1 port, as shown in
a.
Connect the CAN wires to the CAN bus, as shown in
b.
On the last device in the CAN bus, set the CAN terminator switch to ON. The CAN terminator
c.
switch in included on the Reader, Input and Output modules only (the Gateway is always the first
device in the CAN bus). Set the terminator switch to OFF for all other modules in the CAN bus.
Modules are connected using the CAN1 interface. The CAN2 interface is not supported in this release.
Note
Cisco Physical Access Gateway User Guide
2-12
Output Connections: Cisco Physical Access Gateway and Reader Module
1
2
Normally Open (N.O.) connection
C
Chapter 2
Installing and Configuring the Cisco Physical Access Gateway
3
1
2
3
1
2
3
Figure
3
Normally Closed (N.O.) connection
Figure
2-9.
2-10.
OL-32499-01