Cisco Physical Access CIAC-GW-K9 Installieren und Konfigurieren - Seite 16
Blättern Sie online oder laden Sie pdf Installieren und Konfigurieren für Gateway Cisco Physical Access CIAC-GW-K9 herunter. Cisco Physical Access CIAC-GW-K9 26 Seiten. Physical access gateway
Auch für Cisco Physical Access CIAC-GW-K9: Schnellstart-Handbuch (17 seiten)
Seite drucken
Configuring and Managing the Gateway Using a Direct Connection
Other systems that are integrated with Cisco PAM, such as the Video Surveillance Manager (Cisco
Note
VSM), should use the same NTP server setting.
Connecting a PC to the Gateway
To enter the initial Gateway settings or perform other administration tasks, connect a PC to the Gateway
ETH1 port and use a web browser to access the administration pages.
Before You Begin
To configure a Cisco Physical Access Gateway, you need the following:
•
•
•
•
In addition, gather the following information:
•
•
•
Procedure
Complete the following steps to log on to the administration tool.
Connect an Ethernet cable from a PC to the ETH1 interface on the Gateway module.
Step 1
•
•
•
Step 2
Open a web browser on your PC and enter
administration pages.
Enter the default username and password
Step 3
Cisco Physical Access Gateway User Guide
2-16
A PC and web browser.
The Cisco Physical Access Gateway supports Internet Explorer 6.0 and higher.
A Ethernet cable to connect your PC to the Gateway.
Cross-over and straight-through cables are supported.
Your PC must be configured to connect to the 192.168.1.0 network using Ethernet. Use any static
host address on the network other than 192.168.1.42.
Power connected to the Cisco Physical Access Gateway.
See the
"Installing the Cisco Physical Access Gateway" section on page 2-7
The IP Address of the Cisco PAM appliance.
You can use a DHCP server to assign an IP address for the Gateway.
If a DHCP server is not used, gather the Cisco Physical Access Gateway IP address, IP gateway,
subnet mask.
The domain name server (DNS) for the Gateway if DNS names (not IP addresses) are used for the
NTP or Cisco PAM addresses.
See the
"Physical Overview and Port Description" section on page 2-3
Be sure to connect your PC to the ETH1 port. The ETH0 port is used for network communication.
Your PC must be configured to connect to the 192.168.1.0 network using Ethernet. Use any static
host address on the network other than 192.168.1.42.
default username:
gwadmin
default password:
gwadmin
Chapter 2
Installing and Configuring the Cisco Physical Access Gateway
. to access the web-based
https://192.168.1.42
(Figure
2-12).
for more information.
for the port location.
OL-32499-01