Cisco Physical Access CIAC-GW-K9 Installieren und Konfigurieren - Seite 22
Blättern Sie online oder laden Sie pdf Installieren und Konfigurieren für Gateway Cisco Physical Access CIAC-GW-K9 herunter. Cisco Physical Access CIAC-GW-K9 26 Seiten. Physical access gateway
Auch für Cisco Physical Access CIAC-GW-K9: Schnellstart-Handbuch (17 seiten)
Seite drucken
Configuring and Managing the Gateway Using a Direct Connection
Option 1: Local Disk
To upload a firmware file from a local on the connected PC:
Select the Local radio button, as shown in
a.
Click Browse and choose a file from located on a local or network disk. The selected file appears in
b.
the Image Name field. You can also manually enter the directory path and filename.
Option 2: Remote TFTP Server
To upload a firmware file from a remote TFTP server:
Select the Remote radio button.
a.
Enter the TFTP Server IP address.
b.
Enter the directory Path on the TFTP server for the firmware image. Be sure the path and filename
c.
are valid. The administration tool does not verify remote server paths.
Tip
d.
Choose the options that will occur after the image is loaded to the Gateway:
When upgrading Gateway firmware images from a release prior to release 1.1.0, choose all available
Note
options.
–
–
–
–
–
Click Upgrade to copy the firmware image to the Gateway module and perform the selected options (if
Step 5
any).
When all options are selected, wait approximately 10-15 minutes for the firmware upgrade to complete.
The Gateway must be reset to enable the new active image. See the
Note
on page
Cisco Physical Access Gateway User Guide
2-22
The directory path and filename for the remote image displays in the second Image Name field.
You can also enter the path and filename manually.
Active image: (checked by default) make the firmware file new active image.
Reset gateway: (checked by default) perform a soft reset to powercycle the module. See the
"Soft Reset (Powercycle)" section on page 2-25
image are applied only after the Gateway is reset.
Delete credentials: delete the credential data stored on the Gateway.The credential is
automatically downloaded when the Gateway establishes communication with Cisco PAM
appliance.
Delete configuration: delete the module configuration. The configuration is automatically
dowloaded when the Gateway establishes communication with the Cisco PAM appliance.
Delete events: delete all events stored on the Gateway.
2-25.
Chapter 2
Installing and Configuring the Cisco Physical Access Gateway
Figure
2-15.
for more information. Changes to the active
"Soft Reset (Powercycle)" section
OL-32499-01