Epson Perfection V350 Series Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Scanner Epson Perfection V350 Series herunter. Epson Perfection V350 Series 11 Seiten. Product support bulletin(s)
Auch für Epson Perfection V350 Series: Schnellstart (4 seiten), Wichtige Sicherheitshinweise (4 seiten), Ergänzendes Handbuch (2 seiten), Produkt-Support-Bulletin (23 seiten), Update (1 seiten), Produkt-Support-Bulletin (40 seiten), Produkt-Support-Bulletin (24 seiten), Produkt-Support-Bulletin (29 seiten), Produkt-Support-Bulletin (8 seiten), Produkt-Support-Bulletin (3 seiten), Produkt-Support-Bulletin (11 seiten), Produkt-Support-Bulletin (14 seiten), Produkt-Support-Bulletin (12 seiten), Produkt-Support-Bulletin (40 seiten), Produkt-Support-Bulletin (11 seiten), Produkt-Support-Bulletin (40 seiten), Produkt-Support-Bulletin (22 seiten), Produkt-Support-Bulletin (12 seiten), Produkt-Support-Bulletin (21 seiten), Produkt-Support-Bulletin (12 seiten), Hier beginnen (2 seiten), Hier beginnen (4 seiten), Hier beginnen (2 seiten), Hier beginnen (2 seiten), Hinweise und Garantie (29 seiten)

Epson Perfection V350 Photo

Placing Large or Thick Documents

When you need to scan a large or thick document, you can

either raise the lid to its highest posistion, or open the scanner

cover all the way as described below, so that it lies flat next to

the scanner.

1. Open the scanner cover.

2. Pull the scanner cover straight up.

3. Lay the cover down flat next to the scanner.

Note:

When scanning without the scanner cover, gently press down on

your document to flatten it.

4. When you are finished scanning, replace the scanner cover.

To scan film strips or slides, you need to remove the document

mat from the scanner cover. This uncovers the transparency

unit window so your scanner can use it to scan your film or

slides.

4 - Epson Perfection V350 Photo

1. Open the scanner cover and gently slide up the document

mat to remove it.

2. Use a non-abrasive microfiber cloth to wipe the document

table before placing your film or slides.

To place film for scanning in the film holder, see the next

section.

To place film for scanning in the auto film loader, see page 5.

To place slides for scanning, see page 7.

1. Slide your film strip all the way into the film holder with the

shiny base side facing down. Your images and any wording

on the film strip should appear backwards on the side that

faces up.

Note:

Hold the edge of the film gently or use gloves to touch the film;

otherwise you may damage the film.

Make sure the white stickers on the back of the film holder and

the areas around them are not scratched, dusty, or covered in

any way. If the areas are obscured, the scanner may have trouble

recognizing your film in Full Auto Mode.

Do not cover the small holes in the film holder.

8/06