Cisco VG202 Hardware-Installationshandbuch - Seite 44
Blättern Sie online oder laden Sie pdf Hardware-Installationshandbuch für Gateway Cisco VG202 herunter. Cisco VG202 50 Seiten. Voice gateways
Auch für Cisco VG202: Software-Konfigurationshandbuch (50 seiten), Handbuch (10 seiten), Hardware-Installationshandbuch (48 seiten), Schnellstart-Handbuch (19 seiten)
Seite drucken
Initial Configuration Procedures
Set up a console connection to your voice gateway, and enter privileged EXEC mode. For instructions
Step 1
on how to enter privileged EXEC mode, see
page
4-2.
Step 2
In privileged EXEC mode, at the prompt, enter setup.
yourname# setup
The following message is displayed:
--- System Configuration Dialog ---
Continue with configuration dialog? [yes/no]:
You are now in setup command facility.
The prompts in the setup command facility vary, depending on your voice gateway model, on the
installed interface modules, and on the software image. The following steps and the user entries (in bold)
are shown as examples only.
Note
To proceed using the setup command facility, enter yes:
Step 3
Continue with configuration dialog? [yes/no]: yes
When the following messages appear, enter yes to enter basic management setup:
Step 4
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system
Would you like to enter basic management setup? [yes/no]: yes
Enter a hostname for the voice gateway (this example uses VG):
Step 5
Configuring global parameters:
Enter host name [VG]: VG
Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when
Step 6
viewing the configuration.
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret: xxxxxx
Enter an enable password that is different from the enable secret password. This password is not
Step 7
encrypted (less secure) and can be seen when viewing the configuration.
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: xxxxxx
Cisco VG202 and Cisco VG204 Voice Gateways Hardware Installation Guide
4-4
If you make a mistake while using the setup command facility, you can exit and run the setup
command facility again. Press Ctrl-C, and enter the setup command at the privileged EXEC
mode prompt (VG#).
Chapter 4
Powering On the Cisco VG202 and Cisco VG204 Voice Gateways
Step 1
through
Step 4
in the
"Cisco IOS CLI" section on
OL-15959-01