Cisco VG202 Schnellstart-Handbuch - Seite 17

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Gateway Cisco VG202 herunter. Cisco VG202 19 Seiten. Voice gateways
Auch für Cisco VG202: Software-Konfigurationshandbuch (50 seiten), Hardware-Installationshandbuch (50 seiten), Handbuch (10 seiten), Hardware-Installationshandbuch (48 seiten)

Seite drucken

Default settings are in square brackets '[]'.

Basic management setup configures only enough connectivity for management of the system, extended setup

will ask you to configure each interface on the system

Would you like to enter basic management setup? [yes/no]: yes

Enter a hostname for the voice gateway:

Step 4

Configuring global parameters:

Enter host name [VG]: VG

Step 5

Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when viewing the

configuration.

The enable secret is a password used to protect access to privileged EXEC and configuration modes. This

password, after entered, becomes encrypted in the configuration.

Enter enable secret: xxxxxx

Enter an enable password that is different from the enable secret password. This password is not encrypted (less secure)

Step 6

and can be seen when viewing the configuration.

The enable password is used when you do not specify an enable secret password, with some older software

versions, and some boot images.

Enter enable password: xxxxxx

Enter the virtual terminal password, which prevents unauthenticated access to the voice gateway through ports other

Step 7

than the console port:

The virtual terminal password is used to protect access to the voice gateway over a network interface.

Enter virtual terminal password: xxxxxx

Respond to the following prompts as appropriate for your network:

Step 8

Configure SNMP Network Management? [yes]:

Community string [public]:

The system displays a summary of the available interfaces.

Choose one of the available interfaces for connecting the voice gateway to the management network:

Step 9

Enter interface name used to connect to the management network from the above interface summary:

fastethernet0/0

Step 10 Respond to the following prompts as appropriate for your network:

Configuring interface FastEthernet0/0:

Use the 100 Base-TX (RJ-45) connector? [yes]: yes

Operate in full-duplex mode? [no]: yes

Configure IP on this interface? [yes]: yes

IP address for this interface: 172.1.2.3

Subnet mask for this interface [255.255.0.0] : 255.255.0.0

Class B network is 172.1.0.0, 26 subnet bits; mask is /16

The system displays the configuration:

The following configuration command script was created:

hostname VG

enable secret 5 $1$D5P6$PYx41/lQIASK.HcSbfO5q1

enable password xxxxxx

line vty 0 4

password xxxxxx

snmp-server community public

no ip routing

interface FastEthernet0/0

no shutdown

speed 100

duplex auto