Digiway P750E Gebrauchsanweisung - Seite 7

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Toröffner Digiway P750E herunter. Digiway P750E 16 Seiten. Sliding gate motor

Seite drucken

Auto CLS (DIP6)

DIP6 ON selects Auto close mode. In this mode, the gate will auto close after standard auto closed

time. If DIP6 OFF, no this function.

5. Motor Set up

Push Buttons functions

Button

Dip1 on---STD Setting

OPN

Open Length Set

PED

Auto close time set

CLS

Manual close gate

OSC

Lock pulse time set

5.1 MOD1: -- E-code setting: DIP2 off and DIP4 off

MOD1 --

E-code means the encoder is set up at top of the motor and output signal is A and B with

90-degree phase delay each other. Four cores cable with plug directly plug into control board. Two

plugs on control board T4 for right hand side and T5 for left hand side.

MOD0 do not need any limit switch, but with options -- Open limit switch input as manual release

protection input and close limit switch is closed limit switch input

In this mode, gate how to stop: In closing cycle, control will check closed point (encode

count) or closed limit switch if fit, whichever happen first, then stop gate. In opening cycle,

controller will check opened point (encode count) only

Set travel limits – (Gate travel distance setup – "learn" how long the gate)

Method A

a) Connect 240V AC (if not done) and make sure power is off.

b) Releases clutch and push gate to middle position, and then engage the clutch.

c) Make sure no signals connect to OPN, PED, OSC and PEB (use Bypass jumper) terminals. Set

DIP6 on.

d) Turn power on, gate should start close at low speed. If gate opens, turn power off, change motor

direction by swapping any two of three phases output of inverter.

e) Power on again. Gate should start to close. If gate only runs short displace (about 2 seconds time)

then turn power off, change encode plug to another connector.

f) Power on again, gate start close, RED LED is flash and GREEN LED is off. When gate hit the

closed stopper, gate will stop.

g) Set DIP1 on. Push and hold OPN button, gate will start open at low speed. When gate reach

opened position, about 50-100mm before opened stopper, just simply release the OPN button.

Controller will save the current position as fully opened position. While hold OPN button, push

and release PED button will save current gate position as PED opened position.

h) Set DIP1 off and push CLS button, gate will start to close. When gate fully closed, gate will be

ready to operate. Then try to open and close. If not satisfied with the position, just repeat step (g)

to (h). For more details, see Step by step gate set instruction.

Method B --- heavy duty functional mechanical gate opened stopper and closed stopper must be

installed

Connect 240V AC (if not done) and make sure power is off.

b) Releases clutch and push gate to middle position, and then engage the clutch.

Make sure OPN, PED, OSC led OFF and PEB led ON. Set DIP6 on.

P750V5.0 industrial gate motor manual

Motor Set Up

ON=AUTO CLS

Special Setting

Reserved

PE close time set

Reserved

OFF=NO AUTO CLS

Dip1 off---Running

Full open

Pedestrian open

OSC