Crow SH-SIRINT-9F Handbuch
Blättern Sie online oder laden Sie pdf Handbuch für Sicherheitssensoren Crow SH-SIRINT-9F herunter. Crow SH-SIRINT-9F 2 Seiten. Wireless indoor sounder
Auch für Crow SH-SIRINT-9F: Gebrauchsanweisung (2 seiten), Gebrauchsanweisung (2 seiten)
Seite druckenSH-SIRINT-8F/9F
WIRELESS
INDOOR SOUNDER
INSTRUCTION MANUAL
P/N 7105411_B
WALL MOUNTING
Figure 2
Use supplied screw to mount the bracket on the wall
Check that the base is flat against the wall to facilitate the unit
device insertion into the wall
bracket
1.
Slide down the unit device
into the bracket
2.
Reset tamper alarm on
the control panel
PRODUCT FEATURES
The SH-SIRINT is an advanced slim designed wireless
indoor sounder that extends the sound of your alarm inside
your premises.
The SH-SIRINT is ideal for residential and light commercial
buildings, particularly where outdoor sirens are prohibited.
ISM Radio 2GFSK
Ultra Low current consumption
Powered by 2 Lithium batteries Type AA 1.5V
Wall Tamper protection
Battery life up to 5 years
Operating Frequencies: 868-869MHz / 916-917MHz
Event Transmission:
Alarm
Tamper Open/Close
Supervision
Battery status
Bi-Color LED indications
Up to 500m transmission range in open space
Remotely configurable
Selectable Dipswitches for working with panel types :
Shepherd, Serenity, Runner.
BATTERIES INSERTION
Figure 3
Batteries can be replaced by the user
Please refer to section "Battery Replacement" for this
operation.
PRODUCT OVERVIEW
DIPSWITCHS
Dipswitch Setting
Dipswitch
Shepherd
Serenity/Runner
Number
1
OFF -
ON
Serenity / Runner
2
N/A
ON
ARM
Battery
2
ok
Flashes
Low
3+3
battery
flashes
3
N/A
ON
ARM
Battery
2
ok
Beeps
Low
3+3
battery
Beeps
4
N/A
ON
Flasher and Buzzer timeout is 15 min. if
dipswitch is OFF timeout is 2 min.
The table describes the different settings for
SHEPHERD, SERENITY, RUNNER panel types.
Note (for Shepherd default): The Alert sound time is 3
minutes and The Alert flasher time is 30 minutes.
Activation time can be changed from Outputs level (see
installation manual)
DEVICE OPENING
Figure 1
1. Push the latch located on the bracket
2. Slide Up the unit device
PAIRING PROCESS
For pairing process, please refer to your control panel
instructions.
To pair your sounder, please proceed as follows:
DISARM
Enter in installing mode via the" installer Webpage"..
1.
1
flashes
2. Go to Outputs and select the output # you want to
2
learn.
Flashes
3. Add Output – (insert link type "ISM" Device's ID, Device
DISARM
type "smart siren".
1 Beep
2 Beep
4. Set Siren Configuration output, and save configuration.
5. Place the 2 batteries as instructed in figure 3 and wait
until the red/green LED stops blinking.
6. The device should register to the Control Panel.
7. When registration process is successfully completed,
the Green LED will constantly light ON for 3 seconds
and then turn OFF.
8.
If Green LED continues flashing more than 5 minutes
and stopped. Please check siren settings details,
remove batteries and repeat step 5,6,7.