Argos 345/1247 Montageanleitung Handbuch - Seite 7

Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Grill Argos 345/1247 herunter. Argos 345/1247 8 Seiten. Built in

Assembly Instructions
Step 1
Select a site suitable for the
barbecue. Consideration should be
given to wind, over hanging trees
and the surface on which the
barbecue is to be built. Ideally, a
concrete base should be provided.
To establish the correct size, layout
the first layer of bricks (standard
size) and place the ash tray inside
the bricks to ensure that all parts will
be correctly supported. The correct
layout should be 4 bricks wide at the
back and 2 bricks for each side and
4 bricks in the front. Once the
dimensions have been checked,
mark them with twine stretched
around pegs to show the external
limit. Now prepare the mortar and
start building the barbecue.
Common brick size : (H) 6.5 x (W)
21.5 x (D) 10.25 cm
Step 2
Warning : do not place the
barbecue tray on a concrete
surface i.e.. paving slab as
excessive heat can cause
damage and result in injury.
Build up 7 layers of bricks (refer to
diagram). Before laying the 8th
layer, place 2 grill supports
in the mortar on each side
protruding approximately 50mm
(2") from the brickwork, so that they
will evenly support the ash tray
when the mortar is set. One
support in each side should be
approximately 100mm (4") from the
back wall and the other
approximately 355mm (14") from
the back.
Check for exact position by offering
the ash tray up to the supports
before the mortar is hard. Continue
to build up the barbecue to 12
layers of bricks, inserting 4
supports in matching positions
between the 9th and 10th layers
and the 11th and 12th layers. For
these supports, use the grill to
check positioning as the upper two
sets of supports will be used for
this item when complete. At all
stages, check that sides and back
are straight with a spirit level. If the
supports do not properly support
the ash tray or grill, you may be at
risk when using the barbecue.
5
5
8
6