Crow CRRSI01 Installations- und Benutzerhandbuch - Seite 2

Blättern Sie online oder laden Sie pdf Installations- und Benutzerhandbuch für Kontrolleinheit Crow CRRSI01 herunter. Crow CRRSI01 4 Seiten. Runner smart remote

Seite drucken

Installation

Insert the Smart Remote receiver board into the Crow Runner plastic box using the slots

provided to the left of the main PCB. Using the connection lead provided, plug the

connectors into the receiver and the Runner PCB keypad BUS jack (White 5 pin socket).

Wiring Diagram

Programming Smart Remote Receiver to Runner

The Smart Remote Receiver gets enrolled into the Runner alarm panel as a User PIN #.

You do Not need to 'Teach' the remotes into the Runner, They are Pre-Loaded to the

Receiver. Up to 25 Smart Remotes can be learned into a single receiver. All Smart Remotes

will report to the central station and log into the Runner event memory as this single user.

FIRST

we must assign a PIN # to be used for the enrolling of the Smart Receiver.

1. Assign a USER PIN # in the Runner panel. E.g. Program User 10 as 2323 (In

Programming Mode, Press

ENTER

+ ENTER. Then exit installer programming mode).

THEN

we must enroll the 2323 User-10 Code PIN # into the Smart Remote Receiver.

2. Press the program button 'PROG' on the Smart Remote receiver board for one second

(There is a 20Sec Timeout Limit for this PROG Mode),

indicating the receiver is ready to learn the PIN # from the Runner Panel.

3. From the Runner Keypad, Arm & Disarm the system by using the 2323 (User-10) PIN

Code (i.e.:

2323

Smart Remote Receiver will extinguish indicating successful enrolling of the PIN # into

the receiver.

Limit of the 'PROG' Mode, then Power Down the system and remove the Smart

Remote Receiver from the panel and connect it to the white Loom Wire Connector at

the Rear of the Keypad. Then Power-up the system, Perform steps-2 & 3. Power

Down the system and re-fit the Smart Remote Receiver back into the panel.

PROGRAM

(User-10) PIN +

If unable to perform steps-2 & 3 before the Receiver's 20Sec Timeout

ENTER

Enter

and

repeat

+ ENTER,

LED illuminates

same again). The LED on the

Installer

2323