Dillon GTS-1000 Benutzerhandbuch - Seite 9

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Prüfgeräte Dillon GTS-1000 herunter. Dillon GTS-1000 16 Seiten.

GETTING FAMILIAR WITH THE GTS-1000 CAPABILITIES

The GTS-1000 Series features a large working area ideal for testing large samples up

10.2 inches (260 mm)

or parts in tension. T-nuts and screws may be used to secure other fixturing.

Do not allow fluid to run into the T-slots. Tests with potential for running fluids should

secure The Dillon oversized plate accessory (available separately) to the T-slot work

surface and remove the side T-slot cover plates. Always unplug the stand immediately

if fluid runs into the T-slot and do not reconnect until all fluid is cleared and dried.

produce an electrocution hazard. Always unplug the

stand immediately if fluid runs into the T-slot and do

The GTS-1000 includes a handy tension base plate for in-line tension

grips as well. To remove or install, remove one cover plate side

screw and loosen the other. Rotate cover 90 degrees. Slide tension

plate with T-nuts loosely attached in or out as desired. Rotate cover

back and retighten screws.

The GTS-1000 Series is a single column stand designed for vertical use. Maximum

crosshead

travel is 18.7 inches (475 mm).

The GTS offers exceptional working headroom of 22.8 inches (580 mm) with the GTX or

GS force gauge. Over 5 inches (125 mm) of extra headroom reduces travel loss impact

due to fixturing. Extension rods may be required for short samples with low profile

fixturing. In compression, blocks may be used to elevate the sample as needed.

wide. The versatile T-slots can secure unusual shaped fixtures

Do not allow fluid to run into the T-slots. This can

not reconnect until all fluid is dried.

WARNING