Dillon Precision Products RL 550B Gebrauchsanweisung - Seite 12

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Industrielle Ausrüstung Dillon Precision Products RL 550B herunter. Dillon Precision Products RL 550B 18 Seiten.

Seite drucken

Fig. 20 - This photo shows the large powder bar in its

closed position. (Primer system removed for clarity.)

Fig. 21 - This photo shows the large powder bar in its fully

open position. (Primer system removed for clarity.)

On rifle cases, the die should be adjusted so that the

powder funnel will contact the mouth of the case and

then fully actuate the powder bar, Fig. 20 & 21. These

adjustments are accomplished with a case in the

shellplate and alternately raising and lowering the

operating handle, while adjusting the powder die, Fig.

19. When properly adjusted, the powder bar will be

moved to its full rearward position by the case, Fig. 20

& 21. When you have determined that your

adjustments are correct, tighten the lock ring and the

locking collar.

Next, attach the powder measure fail safe rod

assembly to the bellcrank (#17839). Using your thumb

and index finger of your right hand, move the lock-

link down to align the hole with the slot on the

Powder Measure bellcrank (#17839). Then insert the

rod (#97000) through the two holes, Fig. 20. Next,

lower the operating handle (#20636). Insert the powder

measure rod into the slot in the return bracket (#13885)

press the shoulder washer into the slot from the

bottom. Move the operating handle to the priming

position, press the operating handle firmly forward.

Tighten the blue wingnut (#13799) until the top of the

spring (#14033) just touches the underside of the

return bracket (#13885). We'll come back to filling the

measure with powder and adjusting the bar. The

purpose of the powder measure failsafe rod (#97000) is

to return the powder bar to its closed position.

Station Three

In this station the bullet is seated to its proper

depth. You need to refer to a loading manual for

overall length of the completed round.

Put a case into the shellplate at Station Three. Raise

the platform up and screw the die down until it just

touches the shellplate and back it out two turns. Now,

back your seating stem out.

Place a bullet on the case and operate the handle.

Using a dial caliper or case gage, check for overall

length. Keep screwing the seating stem down in small

increments until the correct overall length is achieved.

Once you are satisfied with the overall length, tighten

the lock ring.

Station Four

The crimping operation is performed at this station.

Insert the crimp die and place an empty case in

Station Four. Raise the platform and screw the

crimping die down until it touches the rim of the case.

Now lower the platform and screw the die down an

additional one-quarter of a turn. Place a round in

Station Four with a seated bullet and cycle the

operating handle.

You will need to refer to a loading manual to get

proper crimp dimensions for the caliber you are

loading. A dial caliper is required to take accurate

measurements from your crimped round.

If more crimp is needed, screw the crimp die down

in small increments until you get the desired crimp,

now tighten the lock ring.

* Indicates a caliber specific part. See the caliber conversion

chart on page 16 for the caliber you are loading for.