Epson TM-L90 series Handbuch - Seite 4

Blättern Sie online oder laden Sie pdf Handbuch für Drucker-Zubehör Epson TM-L90 series herunter. Epson TM-L90 series 13 Seiten. Attaching cover on the power switch
Auch für Epson TM-L90 series: Broschüre (1 seiten), Broschüre (2 seiten), Produkthandbuch (27 seiten), Spezifikationen (2 seiten), Spezifikationen (8 seiten), Informationshandbuch (5 seiten), Spezifikationen (4 seiten), Benutzerhandbuch (40 seiten), Benutzerhandbuch (17 seiten), Benutzerhandbuch (21 seiten), Benutzerhandbuch (21 seiten), Handbuch zur Herstellung (22 seiten), Hier beginnen (2 seiten), Hier beginnen (2 seiten), Anleitung Handbuch (12 seiten), Benutzerhandbuch (36 seiten), Handbuch Entwicklung (34 seiten), Handbuch (2 seiten)

How to connect an Epson POS printer with Ethernet Interface

A strip will print showing the MAC address, Gateway (GW), IP address and IP assignment method (manual/auto).

Changing the IP Address of the Adapter

Now comes the tricky part. To be able to change the IP address on the adapter you need to be able to connect with it. To

do this you most likely need to change the IP address of your computer to a value that makes the adapter accessible.

You can then connect to the adapter, make the change to the adapter, then return the computer back to it's original

settings.

Resetting the Adapter

You can reset the UB-E02 Ethernet Interface card to factory defaults by holding down the push button on the card (see

arrow above) while turning on the printer power and continuing to hold it down for 5 seconds. This causes all internal

settings to return to their factory defaults.

Setting the IP Address on your Computer

In Windows you can access the wired Ethernet adapter in the "Network Connections" applet in the Windows Control

Panels (Internet Protocol/TCP/IP properties, allow you to enter an IP address.) Make a note of the existing settings, you'll

be returning to those settings when your done. Set the IP address to an address in the same domain as the adapter. For

example of the adapter shows an IP address of 172.16.10.63 you could change the computer to 172.16.10.2. Do not set

the computer to the same address as the Ethernet adapter on the printer. You might have to reset the computer's adapter

for the new settings to take place.

Logging onto the Adapter using TMNet WebConfig

TMNet web configuration allows you to access the adapter via your network using a web browser. Generally speaking the

adapter must be in the same sub domain as the computer to be able to log on (see previous section for how to configure

the PC to the same subdomain)

http://www.beaglehardware.com/howtoethernet.html[3/4/2011 12:27:20 PM]

(Type II or Type IV)

Using a web browser such as Internet Explorer you should now

be able to connect to the adapter by entering the IP address of

the adapter directly into the address bar of the browser. The

TMNet General Information page show open.

To change the IP address, select 'TCP/IP' under 'Configuration.'

You can enter a new IP address and gateway address.

Press the 'Submit' button when done