Epson ActionDesk 4000+ Spezifikationen - Seite 10

Blättern Sie online oder laden Sie pdf Spezifikationen für Desktop Epson ActionDesk 4000+ herunter. Epson ActionDesk 4000+ 12 Seiten.

EPSON ActionDesk 4000+

Option curd riser board connector pin assignments (S1)

A24 SA7

B 1 8 DFNN

B 1 9 FWRESW Cl3 S D 1 0

*Active low logic

EPSON ActionDesk 4000+ - 10

C12 SD9

Installation/Support lips

Installing Diskette Drives

Make sure that the drive type has been correctly selected in

the SETUP program.

Installing Hard Disk Drives

To take full advantage of the local bus IDE interface, your

hard disk drive must support a 32-bit data path that uses

double-word I/O.

When installing a hard disk drive, see the hard disk drive

type tables and use the auto-sensing feature in SETUP to

select the correct type number for the drive. If the

auto-sensing feature does not produce a match for the

drive, you can define your own drive type by selecting

User as the type and entering the drive's exact

parameters.

Make sure you have installed the local bus IDE drivers on

your hard disk and that the CONFIG.SYS file loads the

drivers.

If you install the IDE drivers and also install Paradox for

Windows or a SCSI drive, Windows may not run correctly.

It is recommended that a 16-bit, AT-type hard disk

controller be used if you are installing a drive that cannot

use the embedded IDE interface. If you install a non-IDE

hard disk drive and controller card, you need to disable

the built-in IDE hard disk drive interface by moving

jumper J35 to position 2-3. If you disable the on-board

IDE, you will not be able to benefit from the built-in local

bus IDE controller.

If you plan to install two hard disk drives in the internal

bays, you must use flat-head screws (#6-32UNC x 8

FH,M,+) to secure the top drive to the mounting bracket.

12/93