Motorola CLP107e Benutzerhandbuch - Seite 32

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Zwei-Wege-Radio Motorola CLP107e herunter. Motorola CLP107e 42 Seiten.

MN007419A01-AA

Chapter 5: Radio Cloning

NOTICE:

Ensure the switch on the cloning cable is set to Legacy.

During the cloning process, no power is applied to the SUC. The batteries cannot be

charged. A data communication is established between the two radios.

3 Turn on the target radio and place it into one of the SUC.

4 To power the source radio, press and hold the PTT button and the - button simultaneously while

turning on the radio until you hear the cloning tone.

5 To start the cloning process, place the source radio in its SUC with an audio accessory, then

press and release the Menu button.

If successful, the source radio sounds a good key chirp tone.

If unsuccessful, the source radio sounds bonk tone.

The tone sounds for no more than five seconds.

6 Turn the radios off and on to bring the radios to the user mode by exiting the clone mode when

the cloning process is completed.

NOTICE: When the radio is in clone mode, the Auto Power Off feature is not applicable.

5.3

Cloning Radios using the Multi-Unit Charger

Prerequisites:

•

A fully charged battery on each radio.

•

CLP Series Multi-Unit Charger (MUC).

•

Both radios are turned off.

•

Source radio: Radio to be cloned.

•

Target radio: Radio to which the configuration of the source radio is to be copied.

Procedure:

1 To put the source radio into clone mode, press and hold the source radio PTT button and the -

button simultaneously while turning on the radio until you hear the cloning tone.

2 Place the source radio into one of the charging pockets that has the CLONE label.

3 Turn on the target radio and place it in the pairing charging pocket that has the CLONE label

and start the cloning process.

4 To start the cloning process, press the Menu button on the source radio.

The source radio generates the start clone tone.

5 To activate the radio, turn off and on the radios when cloning process is completed.

6 To clone another radio, repeat

7 To exit clone mode on the source radio, turn off the radio.

step 3

step