Epson Equity 486DX2/50 PLUS Produktinformation Handbuch - Seite 6

Blättern Sie online oder laden Sie pdf Produktinformation Handbuch für Desktop Epson Equity 486DX2/50 PLUS herunter. Epson Equity 486DX2/50 PLUS 6 Seiten. Product information guide
Auch für Epson Equity 486DX2/50 PLUS: Produktinformation Handbuch (6 seiten)

Seite drucken

Epson Equity 486DX2/50 PLUS Produktinformation Handbuch

Hard disk drive type (continued)

116

548

761

3 9

1022

1024

828

1024

512

615

128

lnstallation/Support Tips

Power

This computer has an automatic input voltage sensing power

supply (between 115V, for USA and Canadian use, and 23OV, for

use in other countries). There is no manual switch

Mouse and Keyboard

When connecting the mouse and keyboard, be careful to

plug them into the proper ports. Although they are

physically identical, they are not interchangeable, and

damage may occur to the ports or the main board.

Installing Floppy Disk Drives

When installing a floppy disk drive as drive B, remember to

set the drive select jumper to the second position and attach

the pass-through connector on the floppy drive controller

cable to the drive, not to the end connector.

If the drive does not function normally, make sure that the

drive type has been correctly selected in Setup. Also check

that any necessary drivers have been installed correctly.

If you have installed two floppy disk drives, remember that

the computer will boot from drive B when a disk is inserted

Installing Hard Disk Drives

It is recommended that a l&bit, AT-type hard disk

controller be used if you are installing a drive that cannot

use the embedded IDE interface. lnstalling a %-bit interface

the standard base l/O address and lRQ(s).

Equity Series Computers

2 0 2 Conner cP3204F

I 115 ! CannrCP30104

1022

, 89

Setup

When installing a hard disk drive, be sure to consult the

drive type table for the drive type parameters (geometry)

which fit the drive you are installing. You can also select a

type with parameters having lesser values, as long as they

do not exceed the maximum capacity (in MB) of your drive.

parameters using the User Defined option.

Software Problems

When installing a copy-protected software package, first try

the installation at high speed. If this does not work properly,

try switching to low speed for the installation If you are still

unable to load the program at high speed, try loading at low

speed and then switching to high speed.

For the Equity 486DX2/50 PLUS, high speed is 50 MHz.

For the Equity 48&3X/25 PLUS, high speed is 25 MHz.

Both systems simulate 8 MHz at low speed.

When using a software package that uses a key disk as its

copy-protection method, try loading it at high speed. If this

does not work, enable Auto Speed in Setup on the Reference

diskette.

Power-on Password

Make sure that you do not forget the Power-on password

you set up. If you do, it wilI be necessary to disable it by

moving jumper JP5 on the main circuit board to position B.

Information Reference List

Engineering Change Notices

None.

Technical Information Bulletins

None.

Product Support Bulletins

None.