DiMarzio angel dp232 Einbauanleitung
Blättern Sie online oder laden Sie pdf Einbauanleitung für Musikinstrument DiMarzio angel dp232 herunter. DiMarzio angel dp232 4 Seiten.
Seite drucken1388 Richmond Terrace • PO Box 100387
Staten Island, NY 10310
www.dimarzio.com
FIG. 1
FIG. 2A
Nanoflex Pickup Top
FIG. 3
Original Bridge Saddle
FIG. 4
Strings
Bridge Saddle
Nanoflex Pickup
Instrument Bridge
The Angel™ System combines the Angel™ magnetic soundhole pickup and the Shadow
Nano ex undersaddle pickup with a specially designed preamp. It includes two volume
controls mounted within the soundhole for easy access. The preamp is powered by a 9-volt
battery (not included), which is mounted in the guitar on or near the neck block in a battery
pouch. The Angel™ System works with standard bronze strings, but nickel-wound and
compound strings can also be used. It will not work with nylon strings. [FIG. 1]
The soundhole must have a minimum diameter of 3½ inches (89 mm).
IMPORTANT: Installation of The Angel™ System is complex. We strongly recommend that
installation be done by a quali ed guitar technician.
INCLUDED IN THIS PACKAGE
(1) The Angel™ soundhole pickup
(1) Nano ex undersaddle pickup
(1) The Angel™ dual preamp module and endpin jack
(1) Self-stick dual volume control assembly
(1) Self-stick battery pouch
(1) 20-inch (51 cm) pickup-to-preamp cable
(1) 12-foot (3.5 meter) cable for no battery operation
(1) ⁄ - inch Allen wrench
(6) Self-adhesive cable retainer clips
(1) Self-adhesive piezo cable retainer clip
(1) Spare set of pickup mounting cushions
(2) Alcohol wipes
(1) Instruction sheet
(1) Warranty card
Please read the installation instructions carefully. Installation of The Angel™ System requires
the use of the included preamp/endpin jack.
INSTALLING THE NANOFLEX UNDERSADDLE PICKUP
Measure the string height of the rst and sixth strings before removing the strings and record
the measurements. Carefully remove the original saddle and drill a hole with a ##42 drill bit
(0.093-inch or 2.40mm) in the corner of the saddle slot at the bass string side of the bridge.
[SEE FIG. 2.] The hole must be drilled at an angle of 30°– 45°. Check the top bracing before
1/32"
0.8 mm
drilling the hole to avoid damage. Clean up the saddle slot and remove all wood dust and
chips. Push the pickup cable through the hole in the bridge and place the pickup into the
saddle slot with "NFX top" showing. [FIG. 2A] To restore the overall height of the bridge,
reduce the
FIG. 2
Top of instrument
Cable
Retainer
Clip
Black Protective Sleeve
THE ANGEL™ SYSTEM DP232
INSTALLATION INSTRUCTIONS
E-6
String
Drilled Hole
(30 – 45º Angle)
E-1
String
Bridge Saddle
Nanoflex Pickup
Bridge