Epson V11H230120 - EX 100 XGA LCD Projector Produkt-Support-Bulletin - Seite 3
Blättern Sie online oder laden Sie pdf Produkt-Support-Bulletin für Desktop Epson V11H230120 - EX 100 XGA LCD Projector herunter. Epson V11H230120 - EX 100 XGA LCD Projector 15 Seiten. Product support bulletin(s)
Seite drucken
Installation of the board in most of the units was quick and simple to do when
following the installation instructions accompanying the boards. Installation of
the SOTA 386si in the Equity I and the Equity II is rather difficult. Due to the
amount of disassembly required, we strongly recommend that only Authorized
Service Centers install the board in the Equity I and Equity II.
Installation Instructions
Equity I
1. Remove the following from the main unit:
a) upper case
b) rear panel
c) front panel
d) FDD/power supply block.
2. Follow instructions for a standard installation for the SOTA 386si in an
8088 - based system. Take care to fold the SOTA connector cable so as
not to prevent reassembly. The cable is sturdy and will tolerate being
folded.
3. Reassemble the main unit and go through the testing and initialization
procedure outlined in the SOTA manual.
Equity II
1. Remove the following from the main unit:
a) upper case
b) rear panel
c) front panel
d) FDD/power supply block.
2. Follow instructions for a standard installation for the SOTA 386si in an
8086 - based system. Take care to fold the SOTA connector cable so as
not to prevent reassembly. This will necessitate routing the cable so that it
does not conflict with the power connection to the main system board.
The cable is sturdy and will tolerate being folded.
3. Reassemble the main unit and go through the testing and initialization
procedure outlined in the SOTA manual.
PSB No: S-0111
Page: 2 of 3