Motorola SM56 Schnellstart-Benutzerhandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Schnellstart-Benutzerhandbuch für Modem Motorola SM56 herunter. Motorola SM56 48 Seiten. Software modem
Auch für Motorola SM56: Schnellstart-Benutzerhandbuch (13 seiten), Schnellstart-Benutzerhandbuch (22 seiten), At-Befehle Referenzhandbuch (42 seiten)

Installing SM56 Software

6-1

IPCI Slots

The SM56 for PCI is PCI Plug and Play compliant. It requires one IRQ ( IRQ 3, 4,...15) and one

memory mapped base address.

Windows 95/98 assigns the modem a COM port number. The SM56 installation software attempts

to negotiate a COM port number in the range of 1-4 in order to support older software and DOS

games. Note that the SM56 PCI modem does not include direct DOS box support. Please refer to

the Troubleshooting section for information on how to get around this limitation.

Installing on Windows 95/98

(Note: The Install Wizard may vary slightly with different versions of Windows 95 and Windows

98.)

On starting Windows 95/98 for the first time after installing the SM56 (ISA or PCI) line interface

card, the Windows 95/98 Configuration Manager detects the new hardware, assigns resources to it,

and then displays a window requesting the modem software drivers. This indicates that the

Configuration Manager is looking for the information (INF) file, which contains information about

the modem, including device type (Modem), device driver information (the name of the driver that

will control the modem) and the AT command/response sets that it supports.

In response to the request window, insert the distribution CD-ROM that contains the SM56

installation software. Select Driver from Disk Provided by Hardware Manufacturer. Windows

should find the information on the disk and identify the device as the SM56 Modem Line Interface

Card. It copies the files from the install disk to the computer.

Note: The SM56 install program may display a message box that reports Cannot locate file

_inst32.ex_... If this occurs, browse and re-point the path to the SM56 installation CD ROM

again. Then click OK.

On boards that have voice capabilities (SM56 Data/Fax/Voice models), another device is found

after the modem has been installed. Windows notifies you that it has found a Serial Wave Device

for the modem and prompts for a Wave Device driver. Re-point Install Shield to the SM56

distribution disk, and click OK.

When these two devices are installed, the SM56 Modem Setup program runs.

SM56 Modem Setup for PCI

The modem setup program for PCI does not prompt for user input during installation. It defaults to

USA country code and Domestic English as the language for the Help files. If you wish to change

either of these settings you may do so via the SM56 PCI Control Panel application (see

Correct SM56 Installation

Data/Fax/TAM/Speakerphone modems the microphone and speaker gain selections are done via

section) after setup is complete. Also, for SM56

Verifying