Epson ES-300C Produkt-Support-Bulletin - Seite 10

Blättern Sie online oder laden Sie pdf Produkt-Support-Bulletin für Software Epson ES-300C herunter. Epson ES-300C 14 Seiten. Laser & non-impact printer error codes
Auch für Epson ES-300C: Produkt-Support-Bulletin (19 seiten), Handbuch (8 seiten), Ergänzendes Handbuch (15 seiten), Handbuch (11 seiten), Produkt-Support-Bulletin (20 seiten), Produkt-Support-Bulletin (25 seiten), Produkt-Support-Bulletin (13 seiten)

EPL-7000 cont.

[S] WARMING UP

The printer is warming up.

Note:

If any of the following messages appear, turn the printer off for at least five

seconds, then turn it back on. If the same message is displayed, repair is

required.

SCAN MOTOR ERROR

HSYNC ERROR

HEATER LAMP ERROR

MAIN MOTOR ERROR

FAN MOTOR ERROR

E-C

Command error. An unidentified command or parameter was detected.

E-l Interface error

a. Incorrect communication parameter received.

b. Broken connector or wire.

c. Host failed to respond within 30 seconds.

d. Host is not accepting data. (DSR= Low)

E-F Fatal error

a. A lamp is broken.

b. Power is applied before the transportation screws were removed.

c. System failure

GQ-3500 DisDlav Codes

Cover Open error

Engine driver CPU error.

Option tray CPU error.

Option tray motor error.

PSB No: P-0077

Page: 9 of 11